20 Most Recent
- Page 11 Questions & Answers
How do you adjust the flame ona danby oven running on propane 20' range
There is normally a small adjusting screw but it must be done by a registered gas technician because of the dangers of the flame blowing out, gas leaking and then being ignited by another ignition source and demolishing your house, as happened in a house near me. Destroyed the house and all around it 100 yards each way!
A 20 foot range is huge, it must use a lot of gas!
on Jul 10, 2020
Need help in renovating homes, Toronto: I am
it is a common thing in and around Toronto, of renovating old homes nowadays,
make sure not to lose the old and classy look of
their place. Yes, but it is not that common to find a good team of renovators
who makes sure of all the works during the renovation. My aunt did her house
renovated couple of months back and it looked fabulous after the renovations.
She mentioned that their services too are good. Check out the link: http://www.avonlearenovations.com,
and try contacting them. Maybe you can find what you are looking for. All the
on Jul 06, 2020
The oven sounds like it is sputtering the whole
While you didnt say if your oven is heated by gas or electric i am going to assume its gas and the cause of that sputtering sound is due to weak ingiter that is not fully opening the gas valve yet its just opening it a wee bit cauing it to basically starve for gas flow and sputtering all the time the gas is flowing. By replacing the igniter the gas will flow properly and stong and thusly the noise will cease and it will heat quickly.
If its electric heated let me know and i will figure why its sputtering
on Jun 14, 2020
Gas oven makes a fluttering sound when pre-heating and cooking
This is most often due to the ignitor bar aging. With time it draws less current and does not hold the regulator valve open all the way. You can confirm that the regulator is OK if the broiler works. Replacement for nearly all of these ovens is a universal part, about $35 at appliance parts stores, takes 5-15 minutes to change (depending on whether you need to pull the oven out to get to the connector).
on Jun 09, 2020
Not finding what you are looking for?