20 Most Recent
Questions & Answers
From the operators Manual page 14:
Each depression of the up or down arrow will
increase or decrease the temperature
incrementally by 1º (F/C) until the desired setting
is reached. The temperature can be set between
36-46º F (2-8º C).
*Note: the display will flash for 5 seconds from
the time the last button was activated before
resuming display of the internal temperature of
on Aug 20, 2020
I just plugged my new one in and am having the same problem too. I was planning on calling Danby tomorrow. Did you figure out what it was?
on Aug 15, 2014
well you are right the CO2 is causing the foam you may need to replace the regulator on the tank it is most likely bypassing the bellows inside...as a temp fix you can shut down the co2 and bleed off the air then just crack open the tank to (hand) regulate the flow ..
on Apr 25, 2014
An EE error code means that you have loose connections (loose temperature sensor connections) check all the wires for a loose connectiontemperature touch padthe units main control boardthe control board is in the back of the unit there is a panel covering in the middle lower back near the compressorInside your unit on the left side in the lower rear theres a vented piece of plastic pry that off thats the temperature sensor make sure all the connections are tightIf the error does not clear then your temperature sensor is faultyyou can get a new sensor atwww.repaiclinic.com.oror atwww.appliancepartspros.comhope this helpedGood Luck!
on Jun 20, 2012
Not finding what you are looking for?