20 Most Recent Fisher and Paykel E522BRXFD Stainless Steel Bottom Freezer Refrigerator - Page 4 Questions & Answers

The F15 error code refers to "Low Current from fan" not drawing enough current or open circuit to fan. Check wiring to fan, check fan motor with Digital Muli-meter for resistance - if open circuit or high resistance - replace fan.

9 is too warm set perameters 1-7 you need sevice check to see what lights are flashing ,in what order

F02 is evaporator sensor "out of range" should measure >45 k ohms. Measure with DVM and replace if out of range.

sounds like the unit is not defrosting you will need to test the defrost element in the freezer

Is compressor running at all?

at the back there is usually a plastic peice covering it

common fault but you needs someone with the right diagnostic equipment

faulty sensor

check the fan that blows the cold air from the freezer to the fridge,this is a common fault it is located between the fridge and freezer compartments

did you turn the control the right way the lsrger the number the cooler the setting

it is behind the plastic panel at the back of the freezer,usually just clips in and pulls out

thermostats are cheap buy a new one and fit it

the higher the number you set it to the colder it gets if the freezer will not cool on high then you have a compressor or gas problem neither is worth repairing

the lamp knob may be sticking try it by hand id so the unit in which it is in has bee assembled incorrectly

this can also be caused by a faulty rely,which is mounted under a plastic cover attached to the compressor

these units are best looked at by someone with the correct test equipment

this is probably one of the two fans has got a little noisey,they are designed to stop as soon as a door has been open so not to blast you with cold air

If there’s an active power source reaching controls, then control board is likely bad.

Most likely defrost drain is clogged