20 Most Recent Dynex DX-E401 Router - Page 9 Questions & Answers

Switches in a mouse can go bad, and it sounds like one in yours has. It is possible to replace the bad switch if a suitable part can be found and you can find someone to do the repair. But it's probably cheaper just to buy a replacement mouse. A new mouse would be the best way to go, unless yours is a very high-end or specialty model. Then see if a computer service shop in your area is willing to make the repair.

from your start menu or if you have vista, click on the vista logo, go into accessories, system tools, and then system restore. This will allow you to restore your system back to a certain date, I would suggest restoring it back to a date before your system go hit by the virus and see if that does the trick.

Clean the key baord and blow it with air clearner/ blower

It is simple.I had a similar situation.All you have to do is to download cain software it is a freeware at http://www.oxid.it/cain.html and run it on your computer with the network card.There is an icon that looks like network adpter it says WEP KEY when you click it it will display your WEP key.

http://www.sparkfun.com/commerce/product_info.php?products_id=8269

have fun.

Hello and thank you for using Fixya.

You may be having IP address conflicts. These can be difficult to fully explain but I included an article with explanation and possible solutions.

Article

u want to enable that feature in win7

That's a stupid question. What code, and where?

I'd say get rid of dial-up, way to slow!

I assume you have the setup disk??

This link explains setup procedure.


http://www.dynexproducts.com/skins/skin_1/Topics/Documents/07-365%20DX-WGRTR%20combined%20-%20WEB.pdf

Probably faulty mouse. Try different mouse pad with no pattern on it.

I'm having the same issue, ive tried everything i can think of but no success so far. I know its something to do with compatability because i tried other mouses and they worked just fine. I'll let you know if i fugure anything out

If it's more than 3 years old, you probably need new batteries.

If the beep started after plugging anything additional into the UPS, you may be in an overload state, and the beep is telling you that it's choosing to beep and not function as intended rather than smoking itself. Try unplugging a piece or two from it and see if the beep goes away. If not, probably just you're batteries giving out due to old age, they'll only give you 3-5 years.

check connections and reboot computer

I answered this the same for another person. Check the adapter to the router with a digital multimeter. If, let's say, the router adapter is supposed to be 9.0 V and it reads 9.5. It's okay.

However, if it reads close to or more than 10.0 V, it is overloading and can damage your system through the ethernet cable.

If it is within tolerance, also check the internet connection with another cable. Outside this, you'd have to get a new router.

Hello jorgecenicer,

The DriversFixed.net web site has a download page for all new Dynex drivers. I hope this helps to fix the modem problem: http://www.driversfixed.net/dynex.php

I thank you for giving a rating to this solution if it has been helpful.

Have a great day,
martyshaw562

Okay, look for a small hole in the router about the size for a small pen or paperclip. It may or may not say reset nearby. Use something that will fit in the hole, I usually opt for an unbent paper clip, and press and hold the button inside the hole for a minimum of twenty seconds. I would recommend disconnecting the router from your network and any power sources first. If you still can't find it, just post the model of your router.