Samsung DVD-HR734 DVD/HDD Recorder - Answered Questions & Fixed issues

just put of for a day and switch back again

check for any bulge capacitor on the power supply replace it with a new one.voltage fluctuation could result to picture freeze.

i think it is due to the software complaint.you just check the software installed in it.

Try Auto re-tune after complete look in manuel tuning menu for chanel sort and change chanel location if needed

1. Press the Repeat button on your remote control
NB: Do not confuse this with the Repeat A-B button
2.
If your player was purchased in Region 1:
Press the buttons 2, 9, 3, 3 and 4 on your remote control, in order one at a time

If it was purchased in Region 2:
Press the buttons 5, 7, 5, 3 and 8 on your remote control, in order one at a time

For Region 3 players:
Press the buttons 5, 6, 7, 3 and 2 on your remote control, in order one at a time

For Region 4 players:
Press the buttons 7, 6, 8, 8 and 4 on your remote control, in order one at a time

For Region 5 players:
Press the buttons 5, 3, 8, 1 and 4 on your remote control, in order one at a time

For Region 6 players:
Press the buttons 2, 4, 4, 6 and 2 on your remote control, in order one at a time

3. The numbers 02 or similar will be displayed on the top left of your onscreen display
4. Press the 1 button on your remote control for region 1, 2 for region 2, and so on, or 9 for multi-region playback
NB: The above step may be time sensitive and need to be performed quickly
5. After 15 seconds have elapsed, power off your player and then power on your player

This problem is down to failure of the laser and an only be solved by replacing it. Samsung are aware of this fault but will only offer a free replacement if the unit is still covered by it's warranty.
They do offer a replacement service but charge £94 for it.

bro you should take it to the repairer,No other options you have. it can't be fixed by doing anything accept changing it's screen or repairing it, if it's possible

Hello. You can check HDMI cable in this case. If you're using an HDMI port that's not working well or has been damaged, it could result in a darker-than-usual screen. If you switch the cable or change devices and the TV is at a regular brightness, this is the case.

It sounds like you might be dealing with backlight bleeding or an issue with the LED backlighting in your TV. This can sometimes occur over time due to normal wear and tear or manufacturing defects. If it started as a faint single brighter section and has now expanded to four, it's likely a hardware issue. While it may not be an easy fix, contacting the manufacturer's customer support or a professional technician would be a good next step to diagnose and possibly repair the problem. If you'd like, you can share the pictures for a more accurate assessment.

All I can advise is to take it to an authorised Samsung repair shop. A list is available on the Samsung web site.

The old yellow, red, white RCA cables are analogue signals, while HDMI cables only carry data. They are in no way compatible. You can buy active conversion boxes that will convert analog to digital, but simple cables cannot work

It can't be done. The Samsung remote will be single frequency for that Samsung device only and the LG remote for that television (or series) only. Companies don't make cross-control between makers easy. The only exception is cable and satellite boxes to allow their remote to also control the television. If you have lost a remote or it doesn't work, this is the answer https://www.fixya.com/support/r29872378-universal_remotes_no_facsimile_remote ..

These LEDs are very susceptible to static electricity damage. What happens when they get zapped is a tiny threading fault starts in the LED crystal. The aluminum contact metal starts migrating into the crack, makes it wider and longer, and eventually goes all the way through the LED and shorts it out. When that happens, the metal overheats and burns out the LED so the entire string goes dead. What this means for you is that the original LED may have been may have been zapped at the factory. The replacement strip likewise, or when it was removed from another TV (if it is a used part), or when you put it in. It should have been in anti-static packaging. You have to be very careful not to touch any of the circuitry on the LED strip, and make sure you ground your hand to the TV metal both before picking up the LED strip and right before connecting the strip to the TV. Better yet, use an anti-static wristband connected to the TV frame. It is possible that the LED driver for that string is pushing too much current, but that's not likely. You would probably notice that part of the screen is unnaturally bright.

It sounds like your TV has a display issue, likely caused by physical damage to the screen due to the bend. Repairing a damaged screen can be quite expensive, often nearing or exceeding the cost of a new TV, especially for larger screens like the one you described. Here are a few options you might consider:

1. Sell it as is: You can try selling the TV in its current condition, clearly describing the issue with the display. Some buyers may be interested in purchasing it for parts or attempting a repair themselves.
2. Attempt a DIY repair: Depending on your technical skills and willingness to take on the challenge, you could try to repair the TV yourself. However, this can be risky and may void any remaining warranty. There are online tutorials and replacement parts available, but again, this route requires some technical expertise.
3. Professional repair: You could contact a professional TV repair service to get an estimate for repairing the screen. Be sure to weigh the cost of repair against the potential selling price of the TV after it's fixed to determine if it's worth the investment.
4. Sell for parts: If repairing the screen is not feasible, you could dismantle the TV and sell its components individually. Some parts, like the internal circuitry or casing, may still hold value to electronics enthusiasts or repair professionals.
5. Trade-in or recycle: Some retailers offer trade-in programs where you can exchange your old electronics for store credit or discounts on new purchases. If the TV is beyond repair, you can also look into recycling options to properly dispose of it.

Ultimately, the best option for you will depend on the extent of the damage, your budget, and your willingness to invest time and effort into repairing or selling the TV.

See troubleshooting section of user manual for help Troubleshooting - Samsung PN51F5500 User Manual [Page 21] ' ManualsLib

Possibly, or dry joints, or failing Caps. Get your meters and oscilloscope out. ..

It's a Samsung and has power supply issues. Repair/replace the power supply and that should get you going, if nothing else is damaged.

see if program set in power set up if no program possible power transformer or board going out

I think you need to check the color settings on your new LG TV and ensure all cables are securely connected. If the issue persists, you don't have further options except to contact LG support for assistance.