20 Most Recent Inland 3500 Consumer Headset - Page 9 Questions & Answers


Please see below. I believe that you have set the tuning to LOCK, hence the KEY symbol. I have done the same thing with other radios. I bet you never forget this!

Manual Tuning with Rotary Dial You can select a higher or lower frequency by turning ROTARY TUNING. Set FAST/FINE/LOCK to select the rotary tuning increments or to lock the ROTARY TUNING dial. The following table shows the tuning increments for the FAST and FINE settings. '------'------'-------'------'-------' ' ' FM ' LW ' MW ' SW ' '------'------'-------'------'-------' ' FAST ' 0.1 ' 9 kHz ' 9/10 ' 0.005 ' ' ' MHz ' ' kHz ' MHz ' '------'------'-------'------'-------' ' FINE ' 0.05 ' 1 kHz ' 1 kHz' 0.001 ' ' ' MHz ' ' ' MHz ' '------'------'-------'------'-------' To lock the ROTARY TUNING dial, set FAST/FINE/LOCK to lock. This keeps you from changing the frequency if you accidentally touch the dial. NOTE: This locks only the ROTARY TUNING dial.

Radio... | Answered on Jun 13, 2019


As a technician, I would think it’s more than likely a parent problem or it could be a battery dead on one of the devices and it cannot see it or there’s too many things generating that particular frequency in that area. Good luck

Radio... | Answered on Jun 13, 2019


very simple you should be able to tell by sound, have someone else talk into mic while you go the audience. I hope you are using a good quality mic and American cables with Nutrek connectors. If you have a mic and cable together I would replace it. You will need to hours studying mic patterns to determine which pattern you will need. I would us a cardiod pattern not an omni pattern. If you are putting your mouth on or too close the sound will be terrible. Practice your enunciation.

Radio... | Answered on Jun 10, 2019


Use the AUX jack, the old cigarette lighter jack to get a 12V feed. It will work fine as long as you are not using a linear amplifier with the radio.

Radio... | Answered on Jun 09, 2019


Ham radio fests, Craigs list, local ham club. Maybe a CERT type of group (citizens emergency response team). We have those and they use ham radios. Also try emergency services in your county. You will never get what you paid....Used Ham gear goes cheap.

Radio... | Answered on Jun 05, 2019


Hi. Google has the user manual at: blob:https://www.cleancss.com/723b15cc-34cb-4c4b-aec6-e3db91bc4499

The info you are looking for is in section 4. Basically you press the shift key to do want you want.

Good Luck.

Radio... | Answered on Jun 04, 2019


I think you will find the problem is in one of the microphone wires. The switch for TX/RX is in the mic, and if the RX wire opens up, you will not get any receive audio.

Radio... | Answered on Jun 04, 2019


Hi,

please try to hard reset both units,
be sure its charged

regards,
Daniel

https://www.rylwy.com/diy-magnetic-loop

Radio... | Answered on Jun 03, 2019

Not finding what you are looking for?
Radio Communications Logo

0 questions posted

Ask a Question

Usually answered in minutes!

Top Inland Radio Communications Experts

eradiostore
eradiostore

Level 3 Expert

1658 Answers

Brad Brown

Level 3 Expert

18522 Answers

Tom Chichester

Level 3 Expert

60403 Answers

Are you an Inland Radio Communication Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Inland Radio Communications

  • Inland Radio Communications

Most Popular Question

will not pair ipad 2

  • Radio Communications
Loading...