20 Most Recent
OKI MICROLINE® 390 FB Printer - Page 5 Questions & Answers
Oki data c9500 belt always dirty
You will find the waste toner auger (Coiled wire in the plastic tube) is either snapped or blocked with hard toner. Its simple to remove as it just unscrews. If I remember correctly it sits under the transfer belt and runs down the back and right side of the base. Anyway clean and inspect it as that is what removes the waste toner.
I am getting a Reboot printer 006-335 message on my OKI B6300
printer.
Your error refers to the ROS motor in the laser unit. Now this means a new ROS Assy (Laser/Scanner) is needed, however if you are technically minded, remove the assy and open it. You will see a spinning mirror. Remove it and clean its shaft and oil with with a very very light oil (Model train oil). reassemble and clean the fixed and spinning mirrors, if it works great and if it does not get some money from the bank and by a new printer. The part number for the ROS is :
062K11210
good luck.
Good luck
Error code 480 on my Oki C9655
480 is not listed in any OKI manual. However the closest to it refers to paper size mismatch. Check your driver setting especially paper size. If in UK make sure its set to A4. if in USA then yours is letter size.
Reset drum on oki c610
There's a small fuse in the drum that blows when it's first powered up after changing the drum. You can emulate a small fuse with an analog VOM set on Amps. With printer OFF, using a light wire like phone wire, connect the VOM to the drum terminals. When you power up, in a few seconds you'll see the VOM needle bounce one way or the other (doesn't matter). The moment you see that, pull the connection from the VOM. You've just impersonated a small fuse blowing. Here's an article on how to make that connection to the drum:
http://www.fixya.com/support/t8952601-reset_drum_life_oki_c3400
Hi,
my Oki c5650 printer keeps
There is a sensor that detects the presence of the cartridge and also a chip reader attached to the LED scanners. First trick is to check the chip. Older machines often become less able to read after market chips. Locate the slot in the side of the cartridge at the end away from the locking mechanism. Carefully prise the cover off and slide out the RF chip inside the recess. Tape this on to the top of the cartridge directly above the recess. Put it back in the printer. and try it. This puts the chip closer to the chip reader and often fixes the recognition problem. A faulty sensor is more difficult to fix and would need a service technician who is more likely to recommend replacing the machine.
I am David i need a remotefor my tv oki
I am David, and I do not have one, and I cannot get one for you.
Try a store where they sell them, or go online at Amazon or E-bay. God bless your efforts.
Not finding what you are looking for?