20 Most Recent Daewoo DLP3212 32 in. LCD Television - Page 8 Questions & Answers

If CRT is weak, it should be replaced. There is no repair to it. Gopakumar Gopalan Google

If you wish to buy its original remote control, contact the authorized service center, or authorized dealer to your device brand. To select a proper universal remote control, you should know about the number of digits to its set-up codes. There are 3 digit, 4 digit, 5 digit, 2 digit and even single digit codes, to some brand devices. After confirming this, check the sites linked here. Both the sites have set-up code list and set-up procedure to many popular brand remote controls. Check which brand remote control has set-up code/s to your device brand, and buy that one according to availability? Brand name of the remote control isn't a matter, but it should have set-up codes in its code list, to the device you have. Please note: Every new universal remote control will have set-up code list, and set-up procedure along with its user manual. Never accept a remote control, that hasn't both of this. If you see the site by "MOSAIC" view, will make surf easier. http://electrohelponline.blogspot.com/

it may 008,000,007,014,015,033,035,053,056,079,... on, more check! http://www.gamesadapter.com/universal-tv... Using a remote control at the TV, you hold down the SET BUTTON , If there is sufficient current, it would have been flashing, Until the voice prompted, when the code is identified use the OK button to confirm. then you can use it ,

Check and replace damaged component/s at its main power regulator stage circuit.

Go to menue look for factory reset and activate it

Try to find the manual on their support site at THIS LINK.

Check whether all the cooling fans on its upper side [back] are working or not. If not, check out the reason. If you wish to get some details, check the site linked here. http://electronicshelponline.blogspot.com/ Pull up older posts. Check the site in 'Mosaic' view. It will make search easy.

Disconnect the base of horizontal drive transistor, and now check it collector voltage. If it is found OK; [almost equal to its iput voltage]; check the voltage that comes to its base, from the IC pin. It should be below 0.1 to 0.25V. If found higher than this, the IC is faulty. If you wish to get some details, check the site linked here. http://electronicshelponline.blogspot.com/ Pull up older posts.