20 Most Recent Whirlpool LGR7648KQ Dryer - Page 8 Questions & Answers

If it has been working and suddenly, have this problem it could very well be the child lock has been activated.

I have added a link. It explains the 5 most common reasons a dryer won’t start.

You should find your answer here: WHIRLPOOL LAUNDRY CENTER Parts Model LTE5243DQ3 SearsPartsDirect

Your heating element is shorted to ground Replace your heating element

the 1st suspect is incorrect or incomplete connections. It is easy to miss something.

How to Disable a Dryer's Buzzer

1. Turn off and unplug the dryer. Since you need to remove the front panels and expose the electrical wiring of the dryer's buzzer you should turn the dryer off and then unplug the machine to avoid shocks. ...
2. Locate the buzzer. ...
3. Pull the buzzer's wires. ...
4. Test the machine.

reference: https://www.hunker.com/13410550/how-to-disable-a-dryers-buzzer

https://www.manualslib.com/manual/321126/Whirlpool-Awz-3303.html

lc==lock ---telling you your control lock is on

does your dryer have a dry sensor ? if so try changing the dial to a different setting that doesn't use the sensor, also some models have a separate button to turn off the dry sensor. it is meant to save energy if your clothes are dry before the time you set

Burrs? Where? Inside the drum? I would use a Dremel Motor Tool with a polishing or buffing wheel.

Either your mister (mistor? mist-er?) is working overtime, or else your dryer vent is clogged.

Yes, there are a couple of fuses inside your dryer, but they don't look like normal, common, household or electronic fuses. Usually one fuese will interrupt the heater circuit, while another one will kill power to the whole dryer.

You may have a loose (disconnected) wire that is supposed to go to your sensor bars.

Should just remove the screws and the lock and flip them over. Generally very easy and quick

it can be replaced but the new one will look just like in a few weeks anyway. Its just thin sheet steel uncoated and the heat comes right through that vent that is why it looks like that as far as rough edges just use a piece of sand paper or emory board or steel wool and rub it smooth. suff gets caught on the grate and the heat can burn it all the black is lint that melted on it but a new one look just like it in like i said a few weeks but to be safe and make sure its not getting to hot get a thermometer and check the temperature during low heat and high heat drying. low around 135f and high around 160f if it goes up over 170 there is a problem you may want a pro to check the unit.

Broken belt.

Depending on your level and ability, it's not really very hard to replace. Heres a YouTube video describing how to do this.

https://youtu.be/GzYmoS9brMY

Circuit breaker? Do you mean the main RCD/ELCB or the MCB (micro circuit breaker) protecting the circuit. The MCB is the modern replacement for a fuse... If it is the main RCD that is tripping it indicates a current leakage to ground that might be in the power outlet or coincidentally in both appliances. If the appliances work ok on other circuits the fault is likely with the power outlet. If it is the MCB that is tripping and the appliances work ok in other circuits, it indicates the MCB might be faulty.

you can google your question for answer , to this or any other question. It is 220Volt AC

is it 220? if so the 2 black wires need to be switched

fixya doesnt sell products