20 Most Recent
Whirlpool ACM184XP Air Conditioner Questions & Answers
The unit is an ACM
Yes, you can remove the unit from it's housing. There may be one or two screws that hold it in the housing. Also, make sure that you have the unit slightly lean outward to allow proper drainage.
Richard
Roth
The
FixYa Team
8/13/2011 5:41:40 PM •
Whirlpool...
•
Answered
on Aug 13, 2011
I have problem with my whirlpool air conditioner.
Unplug the unit and dismantle the off and on timer and remove the plastic back cover until you see the 4 way switch. Using an air compressor clean the terminals of all the contact points. Assemble again and operte.
11/10/2010 4:13:53 AM •
Whirlpool...
•
Answered
on Nov 10, 2010
Trips breaker and wont kick in compressor
you have either a ground or pos -neut fault do not try turning the breakers on untill the unit has been looked at and the fault found it can cause fire and electrecute you! this is a serious fault. if your a bit of a handyman you can have a look and see if any cables have melted and ajoined to a metal part of the unit (most common fault)
if found rap with elec tape and re try unit
good luck
6/25/2010 12:49:31 AM •
Whirlpool...
•
Answered
on Jun 25, 2010
Evaporater freezes up
HELLO THERE:
When you set the temperature settings down around 64 or lower the unit will freeze up so i recommend to keep it at around 68 or 70 ok this will keep it from freezing also make sure that the unit is free of any obstructions so the air can freely get to the unit ok?
best regards michael
8/27/2009 2:23:12 AM •
Whirlpool...
•
Answered
on Aug 27, 2009
No power
The unit itself hs a ground fault built into the plug, is it in the on posistion?
8/25/2007 3:00:47 PM •
Whirlpool...
•
Answered
on Aug 25, 2007
Wirlpool ACQ108XPO
No power at recepticle or you have power to the unit but will not run?
8/25/2007 2:58:58 PM •
Whirlpool...
•
Answered
on Aug 25, 2007
Whirlpool magiccool split AC display showing FC . How do I solve it
Double-check on the exact error code. For
E2, E4, E5, E6, F1, F2, F3, F4, F5, H3, H4, H5, PL, PH, you must turn on the device And disconnect the power supply, then contact the nearest Whirlpool authorized service center.
You may want to check the full list of Whirlpool AC error codes on this link as well:
https://acerrorcode.com/whirlpool-air-conditioner-troubleshooting.html
3/28/2021 3:09:42 AM •
Whirlpool...
•
Answered
on Mar 28, 2021
Not finding what you are looking for?