That is an easy one to fix :>D
If uL (unbalanced load) appears in display, the load is out of balance. The washer is running a load-balance correction routine. Allow the washer to continue. If the dial is flashing and the washer has stopped, redistribute the load, close the lid, and press START/PAUSE.
Hi,
please reset the washer by unplugging it's power for 1 to 2 minutes before plugging the power back in and pressing start. If the issue reoccurs, please switch power outlets and try again. If all else fails, please review the troubleshooting section of your manual.
Thank you.
First unplug the washer. Next grab the seperator on top of agitator pull off then you will see a 7/16 bolt take it out then pull agitator out when reinstalling it back do it in reverse. Good Luck Mike L.
The error code F7 indicates there is a problem with the motor. It fails to get to the required speed for the wash cycle. Make sure the drum isn't too full. Also make sure all transit bolts are removed.
Something could be stuck inside of your washing machines drain or the hose could be needing to replaced or the hose could be kinked or twisted or have holes in it. Or the wires are either broken or loose in the water valve or the washing machines wiring harness and have to be replaced.
Search for the end of cycle signal button then on your dryer This button is located right on the right side of the Duet model dryers.
Push and then hold the button down for about 3 seconds.
The Control Lock LED should shut off then letting you know that your dryer is not locked anymore. Or it could be the child lock feature was turned on and needs to be turned off.
It is probably a power supply issue.
I would replace the main smoothing and secondary smoothing capacitors on the main board.
The voltages go lower than they should be and it confuses the board.
read the manual yet, why not?
most things like this need a new filter
and need fully cleaned.
or condensate pan is too full of water.
all this is in the manual if you read it.
and keep it on hand as manual like to go byebye old on the www
https://www.manualslib.com/manual/1834294/Whirlpool-Wdh70eapw.html
see page 10 drain hose ALL WRONG
got the optional PUMP< we can't see it./
it says clear as day E1 E2 is call for service
why not do as it tells.