20 Most Recent OKI C5800dn Laser Printer - Page 8 Questions & Answers


Have seen this before and its probably used on an extension lead. Although the led on the extension may be lit, there is no power to the actual socket. try plugging straight into a known working wall socket. Have you tried another mains lead?

OKI Office... | Answered on Sep 09, 2018


The only thing in common with both of the printers is the USB cable you are using. Try another one.

OKI Office... | Answered on Sep 09, 2018


The toners that you have bought are most probably not for your country or have the chips missing so the machine cannot identify them correctly. If they have no chips you can remove the old ones and fit them to the new ones. I would just send them back to your supplier and get the correct ones.

OKI Office... | Answered on Aug 04, 2018


231 Is a RFID error. I have seen this a few times and can be caused by rf interference. If you have any electrical device sitting very close (ie router/pc/hub/media centre/microwave etc. This will cause a 231 error.

OKI Office... | Answered on Jul 23, 2018


980

An error occurred like paper curling to the fuser unit.

OKI Office... | Answered on Jul 17, 2018


You cant find the reset because there is not one. OKI do not use resets to cure errors. Yes a 980 is paper wrapped around the hot or pressure rollers in the fuser. Normally you just take out the fuser and remove the paper and it will start working. However this MUST be done with the power OFF. So it should be a case of just turning it off and removing the jam and refitting the fuser and turning it back on. If the error is still there then alas a new fuser is require to get it going again. You may be able to buy a fuse from suppliers on the net, fit it and that will do the reset without the need of buying a fuser.

OKI Office... | Answered on Jul 15, 2018


There is no reference to your problem in the C5100 Service manual. I have 17 years experience on OKI printers and never heard of this error. it must be specific to a program you are using. try printing the windows test page and if that is ok consult the people who made the program as that's where the trouble must lay.

OKI Office... | Answered on Jun 30, 2018


Look for a strip of plastic running the full width of the printer. Its called an encoder strip. The sensor in the carriage looks at the encoder and counts the markings on it so it knows where to be. The strip can be dirty or marked and the carriage will have trouble reading it. Gently use a foam cleanser and wipe the strip clean. be careful as it is easily damaged. If you still have problem then a new "Space motor" is required.

OKI Office... | Answered on Jun 30, 2018


With OKI its a software issue. If you remove a drum and refit it it can screwup the software and a grey backgound can be the result. Usually powering off an on cures and or remove all consumables and let the machine error and then turn off then replace the consumables and power up again and alls well. Also you can have a bad earth contact on a drum/machine. Make sure all contacts are clean and touching each other.

OKI Office... | Answered on Jun 30, 2018


Doubtful. Usually manufacturers imprint the chip on the cartridge to the specific model its made for. Remember not all toners are the same. Toner power comes in different sizes and there is no "Generic" toner.

OKI Office... | Answered on Jun 30, 2018


This is a very unusual error. It refers to the internal flash memory. Hold down both menu keys (Up and down) and power up the printer. Go into the maintenance menu,Use the menu keys to the heading called "Flash Format Execute". Press setting key and it will intitialize the flash memory. Turn off and on and hopefully all will be well. If not then buy a new printer and cost outweighs repair.

OKI Office... | Answered on Jun 30, 2018

Not finding what you are looking for?
OKI C5800dn Laser Printer Logo

17 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top OKI Office Equipment & Supplies Experts

Alvin Barnabas
Alvin Barnabas

Level 2 Expert

134 Answers

Timothy Van Der...

Level 2 Expert

152 Answers

Mike

Level 3 Expert

4369 Answers

Are you an OKI Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

C OKI

  • C OKI

Most Popular Question

oki c5800 printer sensor malfunction

  • Office Equipment & Supplies
Loading...