20 Most Recent Dometic 640315 Duo Therm 13,500 BTU Penguin Low Profile Air Conditione - Page 6 Questions & Answers

If all appears OK, no noise, good cooling suggest check thermostat. If the thermostat is allowing the compressor to short cycle, restart under load the breaker would be expected to blow do to overloading the compressor. There is usually a 5 minute time delay in the thermostat that prevents this.

Turn power off take pictures !! If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

I believe it is supposed to have a 15. Remember, breakers are installed TO PROTECT THE WIRE, NOT THE EQUIPMENT. If a breaker is tripping you just don't put a bigger breaker. The wire must be the correct size for the breaker. Take it to the manufacture. If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Lol. What kind of help?? Physical? If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Most common problem with any refrigerator not cooling is a clogged radiator. Can you access it and vacuum it with power disconnected? Clicking may be obstruction hitting fan blade as it turns. Hope this helps.

That is normal. Typically a unit doesn't maintain the exact Set point temp. If set for 75 it cools to 74 and doesn't restart until 76. Obviously if getting too much higher than that there is a problem. Units also are programmed with maximum and minimum run times as well as how many times it can cycle per hour. Hope this helps! If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

There isn't one. Every a/c unit is a piece of junk. Just like your t.v., fridge, and microwave. Buy cheap, replace when it breaks down. It's all luck, so Good Luck!! Best Wishes!! If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Try plugging the hole in the wall where the wire comes through. Also be sure you are not trying to reach your humidity set point therefore overshooting your cooling setpoint. Referred to "droop" in settings If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

It could be that the contactor is stuck closed .The contactor is where the compressor wire goes to .There should be 2 low voltage wires (24 volt) that connected to either the side or top back of the contactor ,you can just pull 1 wire out ( shut power off unit first) then when power back on and compressor still run that mean the contactor is bad and needed to be replaced

All AC units create condensation from the cooling of air (cold/cool air hold less water than warm air), it is worse in areas of humid air like the Midwest for example.

notify a refrigeration repair and they will need to diagnosis and test systems or an rv repair shop

Likely as simple as a float switch. Meaning the drain is backed up. 24 volts starts at transformer, then to fuse, then to float switch, then to tstat. Find where the voltage stops. Use your tongue If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Check the water inlet valve.