20 Most Recent GE DSXH47EGWW Electric Dryer Questions & Answers

I was told by repair man that it is in the circuit board and it woukld have to be replaced. It stopped when I turned it down to Medium. My clothes still get dry!

is there an error code displayed,then check tech spec sheet located inside unit? if no code,try measuring between pins 1 & 2 on plug J-4 if you have 120volts a.c. its the control board,if 0 volts are found then its the door switch

if that beeps on it's own and lights come on most likely when this happens it's the computer board,i've seen them start up just sitting there it will beep and then turn on.

disassemble from the front, remove the belt & there you go & if your not sure get a service tech so you dont do more damage

some times the number of flashes and pauses will be an error code counting them could result in a solution also try turning off the breaker count to 5 turn on see if helps

I would replace parts. It still is cheaper than a new unit. So get the new control panel and do it yourself and save money. The average life of a dyer is dependant only on when the owner gives up. I just serviced on last week that was 25 years old.

bad thermostat