20 Most Recent Whirlpool RCS3014 Electric Cooktop - Page 2 Questions & Answers

What is the model number?

You didn't mention if it only pops when you first turn them on or that the popping is continuous. If it when you first turn them on, then I would suspect late ignition. Too much gas build-up before ignition takes place. The spark gap may need to be adjusted or the spark module replaced. If it happens continuously there may be a short in one of the switches or wiring harness.

and the problem is? please post afresh with full details

Sometimes after a power failure the p c board needs re setting. Turn off the power for a few minutes that allows it time to re set. Turn it back on then individually turn on each element for a couple of minutes.

Hi, Recheck the wiring to that switch you replaced, the light circuit was wired wrong, some switch have moved terminals on them so recheck them all. Good Luck I’m happy to help further over the phone at https://www.6ya.com/expert/gere_bf68e6055dd61249

Lift the top of your stove, then look for a connector or plug, wire that has pushed up near or against the stove top. Where the wires connect to the burners one or more may be loose an needs tightening.

power off to the stove at the electrical switchboard.wait a minute then power on again, set clock again, any better?if not, call the repair man.