20 Most Recent
RCA RCR460 Remote Control - Page 8 Questions & Answers
Rca led52b55r120q wont turn on. the red light comes on when plugged in but when power button is pressed red light turn off and tv does not turn on.
Sounds like The main power supply regulator section circuit fault. Either it will be a separate board, or the part of main board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Pull up older posts.
http://electro-medical.blogspot.com/ It will be best to replace the power supply regulator board as card basis rather than making "Surgery" to it; which usually will make loss for both money and time. Even though you can make it right, it will cost around an amount equal to the cost of a new board; including the cost of (spare parts + service charge) More to say, most of the spare parts to it will be difficult to get from open electronic spare part market. This is true to most of the flat panel TV power supply boards; irrespective of its brand and screen size.
Search the site by type in the "brand name" to your device; in the "Search box at the top right of the display window of the Homepage" to get gathered related posts.
Hannspree wont turn on, intermittent power light?
HI, I'm not familiar with this brand set but in most cases, you can't replace a main board from another size set and have it work. I'd get the right board and see if that fixes it. I'd say the power supply voltages are ok, anything within 10% of rated should be ok, but the voltage to the tcon doesn't sound right, again a main board issue.
RCA LED55C55R120Q PUSH POWER BUTTON MULTIPLE TIMES TO TURN ON
That has to be one of the longest questions I've seen on here but unfortunately it doesn't help figure out what's going on, you've replaced the power supply a couple times, but you didn't say anything about testing the 5 and 12 volt rails to see if you have the correct voltage and if it's free of ripple. Have you tested the "on pin" on the power board to see if the power supply is being commanded to come out of sleep mode and turn on? Another thing to test is the on command to the main board, I'd have to pull a service manual to see what it should be but generally it's around 2.5 volts on most Funai brand sets. To be able to repair a TV it generally takes some electrical engineering knowledge and takes more than just replace some boards and hope it helps.
Not finding what you are looking for?