20 Most Recent Integra Dtr-20.3 THX Select2 Plus AV Receiver Questions & Answers

I have an Integra DTR 20.3. Recently, I have been getting no sound from the speakers after removing the headphones from the headphone jack. Any ideas?

Usually the headphone jack has a contact that's "made" by the 'ring' section of the jack when you push in the plug, which bypasses the speaker circuit (that's what automatically silences the speakers when you plug in the headphones when there are no switches to turn the speakers on/off manually)... if the 'ring' strip got bent somehow so it's pressing against that contact all the time, it won't let the speakers' circuit come out of bypass. Look inside the jack with a flashlight... the sideways Vs that touch the 'ring' sections of the stereo headphone plug should be about in the middle of the opening... if they're pushed over too far it may require disassembly to bend them back to the proper position.

Integra Dtr-20.3... | Answered on Mar 08, 2015

1 Answer

No video

You have a defective processor pcb. repair shop must change bd.

Integra Dtr-20.3... | Answered on Feb 19, 2015

1 Answer

How do I fix Cbt/sat no signal

The processor pcb board will need to be changed

Integra Dtr-20.3... | Answered on Feb 19, 2015

1 Answer

Sounds stop working

You will have a defective processor pcb.

Integra Dtr-20.3... | Answered on Feb 19, 2015

1 Answer

Will not power up only repetitively clicks when plugged in

:-(

Integra Dtr-20.3... | Answered on Sep 07, 2014

0 Answers

When I use hdmi to plug my laptop into my Integra 20.3 receiver, network control of the receiver shuts down. I can't even ping the receiver unless I shut down the laptop. Can this be fixed?

Integra Dtr-20.3... | Posted on Feb 11, 2014 | Be the first to answer

0 Answers

The original remote for my Integra DTM-5.3 no longer communicates with the receiver. New batteries didn't make a difference nor did a new remote. What steps are needed to correct this?

IR receiver issue. Send the unit and the two remotes back to the maker for service. The address is on the last page.

http://filedepot.onkyousa.com/Files/own_manuals/DTM-5.3_(v3).pdf

Integra Audio... | Answered on Aug 02, 2020

0 Answers

Integra dtc-9.4 processor speakers set up

Integra Audio... | Posted on Sep 25, 2018 | Be the first to answer

0 Answers

The mute buttom on my integra dtr 7.8 actually turns the volume up instead of muting.

Integra Audio... | Posted on Aug 23, 2018 | Be the first to answer

1 Answer

My integra av receiver model no DTR-70.1 amplifier displays but no sound what could be the problem?

http://www.integrahometheater.com/faqs.php Check the connections and try a master reset?
Perform a master reset. To do the reset you need to turn the receiver on, then on the front panel of the receiver press and hold the "VCR/DVR" button while doing that press the "STANDBY/ON" button. You will see the word "Clear" in the display screen and the receiver will go into standby mode.

Integra Audio... | Answered on Jul 03, 2018

0 Answers