20 Most Recent Whirlpool GS6SHEXNL Side by Side Refrigerator Questions & Answers

funny you asked this question i just had this same problem this week at a customers home. you need the electronic control board located in the compressor compartment behind the refrig. it is mounted in the white box on the left hand rear corner. the whirlpool part number is 2304095 and it is around 175.00 i'm not sure who a local part supplier around you would be if all else fails you could get thru sears..

Whirlpool... | Answered on Aug 07, 2019

normally no,,,, at the ends of the handle you pry off a cover exposing the screws that hold it on.then snap the cover back on or they slide up and off

Whirlpool... | Answered on Sep 01, 2014


Check out these tips...they can help you figure out whats going wrong with yourrefrigerator and why it is not cooling

Refrigerator not Cooling or Fridge not Cooling

How to Defrost Refrigerator Defrost Timer Problem

Water Running in refrigerator from Freezer

Refrigerator or Freezer not Cooling or Getting Cold

Whirlpool... | Answered on Jan 08, 2014

Replace that part and that will solve this problem. 2198202 Temperature Control Thermostat

Make sure you unplug the refrigerator before beginning work, Sea Breeze

Whirlpool... | Answered on Feb 13, 2013

Replace the water inlet valve assembly. It has a stuck solenoid. Here is the part to order.

Whirlpool... | Answered on Dec 03, 2012

Check and clean the coils at the condenser and fan on the rear of the unit.

Whirlpool... | Answered on Nov 11, 2012


Download and look at # 7 on the bottom

Whirlpool... | Answered on Jul 20, 2011

Ice maker not making ice. Ice in tray but does not fall

Whirlpool... | Answered on Mar 27, 2011

Can you tell me the switch name you need or the problem you're having with your unit and how did you came up with the switch been defective??

Whirlpool... | Answered on Oct 12, 2010

I had the same problem. Ice maker works fine. Removed the kick plate at the bottom of the fridge to expose the water line. I disconnected it and then pressed the dispense button. Water pumped out of the line so i know water was getting all the way to the freezer door. I went overkill but it worked. I removed the freezer door and placed it outside. (disconnected the power to the door by disconnecting the plug at the top. and then removed two screws/bolts at the top and the door lifts up and off) I set the door on a patio table with the bottom facing up. I picked up some 16 gauge wire ($6 at Home Depot) and ran it up the water tube from the bottom of the door. The bottom is more of a straight shot up the water line. I also took a turkey syringe used to inject juice into a turkey and i shot very hot water up the line with the door upside down. This allowed water to run up the line and unfreeze it if it was frozen. I let it sit outside for 30 minutes and put the door back on and now it works like a champ. The line was either frozen or it was obstructed. The water line is surprisingly small. Took less than an hour and I now have water again. Not tough at all...

Whirlpool... | Answered on Oct 07, 2010

You need to replace the switch to the dispenser. This is a common problem on Whirlpool refrigerators.

Whirlpool... | Answered on Oct 02, 2010

you will have to remove the inner liner and tighten the bold from inside . mm

Whirlpool... | Answered on Sep 01, 2010

Not finding what you are looking for?
Whirlpool GS6SHEXNL Side by Side Refrigerator Logo

75 questions posted

Ask a Question

Usually answered in minutes!

Top Whirlpool Refrigerators Experts

John Tripp
John Tripp

Level 3 Expert

4656 Answers

Michael Thomas
Michael Thomas

Level 3 Expert

3053 Answers


Level 3 Expert

85239 Answers

Are you a Whirlpool Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Whirlpool Refrigerators

  • Whirlpool Refrigerators

Most Popular Question

whirlpool side side refrigerator

  • Refrigerators