The E732-001 error on a Canon iR 3225 indicates an issue with the fixing assembly temperature. Here are some steps to troubleshoot and resolve this error:
Reset the Condition:
Enter service mode by pressing the following sequence on the control panel: COPIER > FUNCTION > CLEAR > ERR.
This will reset the error condition. If the message disappears, your printer is ready to use. If this doesn't work, there may be a hardware problem as addressed below.
Replace the Main Thermistor:
The main thermistor is responsible for temperature sensing. If it's faulty, it can trigger the E732-001 error.
Consider replacing the main thermistor to resolve the issue.
Check the DC Controller PCB:
If the problem persists, inspect the DC controller PCB for any defects or malfunctions.
Replacing the DC controller PCB may be necessary.
Remember to turn off the printer before performing any maintenance tasks. If the error persists or if you need further assistance, I recommend contacting your local authorized Canon dealer or the Canon Customer Support Center for professional service
Code: E197-0000
Description:
Error in communication of Laser Driver PCB (PCB14)
(Communication error 1 with image PCB).
Remedy: 1.Check the cable. 2.Replace the Laser Scanner Unit. 3.Replace the DC Controller PCB (PCB4).
Question edited for a lot more clarity.
Please don't type in all CAPS.
Re: Imagerunner 2380i - E000990-0000The sensor is probably blocked with toner, it's not a pleasant job.
May 22, 2022
Fixyahttps://www.fixya.com > ... > Canon > iRC2380i
Aug 30, 2012 - This error is usually caused by the waste toner shutter opening and shutting detection photo interrupter getting soiled, if you remove the black ...
There is a workaround that will work for many dos based programs.
It will remove several of the advanced feature from your printers functionality but may solve the problem.
Try this:
Open control panel, switch to classic view if not already in it. Open the Printers folder, then Right-Click on the Canon MF6540, select properties.
Once it opens the instruction may vary slightly for your printer but should roughly be:
1. Select the advanced tab, then click print processor, then select one of the RAW modes on the right and Ok twice to close the windows.
2. Try printing in the DOS program, if it fails, repeat step one and try the next option. If none of the RAW modes work, try the TEXT mode.
If none of these methods work you may need to emulate a LPT Port for the DOS program to Print to, forward it to the Printer and then repeat the above process. DOS programs are notoriously finicky about settings so you will likely have to try several settings to find one that matches.
If your first attempts fail and you need to emulate the LPT port get back to me by adding a comment to this post and I will see if I can find a good emulator to try for you. Or you can buy a router to connect the printer to that already has emulated LPT software such as the Linksys WRT610N. Sharing the printer through such a router creates a virual LPT port on your computer which may work.
If you need more direct help, try clicking my name and clicking Ask Me for paid support. If you can handle the normal speed here in the forums simply reply and we will help you as soon as we're able.
Canon Printer Error 5200 may occur if the ink level in your printer is low or if you have a defective ink cartridge. Follow the steps to fix Canon printer 5200 Error code:
·Refill your cartridges/Ink tank
·Clean printer cartridge
·Factory reset printer
Find here the more canon printer error codes and their solutions.
