20 Most Recent GE GLD5900NWW / GLD5900NBB / GLD5900NCC Dishwasher - Page 4 Questions & Answers

Are you able to select cycles. Is there any water in the bottom of the dishwasher.

possible resrtriction, weak water pump!

Possibly not enough water. Water valve may need replacing

Check your manual http://www.manualsonline.com/

It is normal for there to water above the sump area on that model dishwasher. How this unit works is...the timer send voltage to the drain solenoid for a short period of time, then disconnects the power. The water pressure that is created by the pump is what **keeps** the drain valve open, until the water pressure/volume is low enough for the drain valve spring to overcome and the valve closes. I assume that you have cleaned the air gap out?

usually websites online for help with codes

If it is electrically activated, it is probably a loose wire from the timer control or possibly a bad timer switch.If it is mechanically activated, it may be a broken plastic part in the actuator or at the door itself. Good Luck..

Try this youtube video .... each manufacturer has quite different ways to remove the wash spin arm to get to the filters ... https://www.youtube.com/watch?v=7jW0de4HmVM Helpful??

Those beeps are a fault code. - check the service manual for what to do next,

Probably need to replace door latch / switch assembly

Could that possibly be a GE Dishwasher with a slightly different model number?https://products.geappliances.com/appliance/gea-specs/GDF630PGMWW

u can start by looking and checking all hoses going in and out of dishwasher. usally not hard to locate sometimes a clog will back water up the spout and cause the leak message

If there’s a thermal fuse, replace it.

What is model #?

Keep trying.

may be hinge or spring cable hinge https://www.youtube.com/watch?v=J9vqr4L8StY spring cable https://www.youtube.com/watch?v=6calYe1J6Ps