20 Most Recent Ariston Technologies L63 Free-Standing Dishwasher - Page 8 Questions & Answers

Try removing all power from machine and leave it for 20 minutes

Reconnect and switch it on

It should reset to factory setting on power restore

Try unplugging the dishwasher for one minute then plug back in. If that does not work make sure that the controls were not locked. Sometimes there is a control lock to keep children from starting the dishwasher. Look for a button with a lock on it. You may have to press and hold this button for like 5 seconds or you may need to press a couple buttons together to unlock the panel. If this is not the case there may be a problem with the control panel. Remove the inner panel on the door and inspect the ribbon connector. Make sure the connector is fully inserted and the ribbon connector does not have any evidence of electrical damage. Worst case the control panel may need to be replaced.

usually the push/pull handles that turn older dishwasher on and off simply twist on and are threaded -- you shouldn't have to dissasemble anything... get a replacement and twist it on... "righty tighty" if I'm not mistaken

sounds loke the drain is lower than the machine, is it new install or been moved recently? try raising the drain hose middle section a foot or two above the ground.

I trowed away.

I have the 6040 model, and it has a number of buttons on the left, and a dial on the right.

if yours is the same, then you need to select a program using the buttons "Normal" for example, then turn the dial to just after the top A selection (I mean just after this, by a few mm, it clicks past the A slightly)

this will then do a pre-was, and the main wash you have selected.

The other buttons are fairly self explanatory, like half load for a half load, pre wash to only do a pre wash etc...

Hope the helps!

Most Ariston Technologies dishwashers include a 5 year warranty. When did you purchase?

I found a very good page for this problem on the internet - http://www.almesberger.net/ld87/al03.html -
After reading that page, I knew exactly what to do. In my case, something had stopped the pump from working, So I could solve the problem without removing the pump.

dear sir vif you have used liquid soap in your dishwasher it will make mountains of bubles to kill all bubles outin a hurry take a sos pad put it in your machine and run the dishwaser this will remove all of the soao instantly try it it really works i am in the dishwasher bussiness and it does work thanks from gilles