Top 20
Sunbeam SCA103RWB1 Room Air Conditioner Questions & Answers
Where can I get a
Go to your local hardware store go down the aisle where they have the new window A/C units and BUY A NEW ONE!!
8/19/2011 10:00:54 PM •
Sunbeam...
•
111 views • 0 helpful votes
Sunbeam A/c 10000 BTU displays
Hi
EE error reminds you to clean the filter, to clean it turn the unit off and unplug it, then clean the filter completely. After cleaning if the issue returns then replace the filter. Hope this helps...please post back for further assistance.
Daniel
5/26/2011 12:24:40 PM •
Sunbeam...
•
145 views • 0 helpful votes
Sunbeam Model No. SCK 14200 DR no cooling...
Un plug a/c from wall and remove the screws from the electrical compartment of the unit and locate the thermostat, remove the 2 wires of the thermostat and use ohms meter to check the part for continuity, if you dont have continuity with t-stat turned down below room temp., replace thermostat.Good luck.
3/5/2010 8:47:56 PM •
Sunbeam...
•
1,400 views • 2 helpful votes
Air conditioner won't turn on. Showing EE on the LED
hello. i can help you.
Check to see if there is power getting to the air conditioner. If it is a 110-volt unit, plug a lamp or other device into the same outlet the air conditioner is plugged into. If there's no power, check the fuses or circuit breakers. If there's still no power, you will need to contact a qualified electrician to restore power to the outlet.
If there is power to the appliance but it is still completely dead there may be a problem in one or more of the following areas:
- Wiring (Inspect for any broken or burnt wiring)
- Thermostat
- Compressor
- Overload and/or relay
- Selector switch
- Control board
Work on these areas of an appliance may require help from an appliance repair person or other qualified technician.
6/8/2009 9:59:18 PM •
Sunbeam...
•
482 views • 1 helpful votes
Turn on and off the unit
-Check the setting of your temperature.
-Check if the timer is not set.
-Check if no restriction in your outdoor or indoor and outdoor are both clean.
-Check if no error code (flashing light) at the indoor.
1/7/2008 9:59:11 AM •
Sunbeam...
•
168 views • 0 helpful votes
Sunbeam BL0750 electric blanket green light blinking
Sure, here are a few suggestions on where to find a replacement controller for your Sunbeam BL0750 electric blanket:
* **Sunbeam customer service:** You can contact Sunbeam customer service directly and they may be able to help you find a replacement controller. Their contact information is available on their website.
[Image of Sunbeam customer service website]
* **Online retailers:** There are a number of online retailers that sell replacement controllers for Sunbeam electric blankets. A quick search should turn up a few options.
* **Local hardware stores:** Some local hardware stores may also carry replacement controllers for Sunbeam electric blankets. It's worth checking with your local store to see if they have any in stock.
Once you've found a replacement controller, you can either install it yourself or have a professional do it for you. If you're not comfortable installing the controller yourself, you can take your blanket to a qualified electrician or repair shop.
Here are some additional tips for troubleshooting your Sunbeam BL0750 electric blanket:
* Check the power cord to make sure it's plugged in securely.
* Try using a different outlet.
* Check the fuse or circuit breaker to make sure it's not tripped.
* If you've tried all of these things and the blanket still doesn't work, you may need to replace the controller.
I hope this helps!
Not finding what you are looking for?