20 Most Recent
Amana LWA40A - Page 5 Questions & Answers
My AMANA washing machine stops in the wash cycle NTW4516FW1 does not continue to rinse cycle
Is it heating the water? Many machines won't continue the wash cycle if the water temperature isn't achieved. Usually caused by blown heater element. I'm not familiar with your machine but generally it's a matter of removing the back panel, disconnect the terminals to the heater element, undo fixing bolt and pull it out. Should have a resistance of around 50 ohms, but if you're water isn't getting warm it's probably open circuit, ie infinitely high resistance. Replacement element is usually around £20.
How to add fabric softner to the amana washer with locking lid
Check and see if there is a cup in the top of the agitator. Some machines have you put it there, turning back and forth during wash doesn't bother it, but the spin to empty the wash water causes the softener to go out through slots in the top of the cup and be held in the agitator. when it stops the softener drains into the tub, ready for the rinse cycle.
Amana front load washer error code "nd". Door is
Hello there and welcome to fixya From what you're describing it sounds like the drain pump is blocked.
The nd error code indicates "no drain". If the unit can't drain it won't
spin. You're going to have to slide the washer out far enough to remove
the rear panel; be careful not to damage the floor. Once you get the
rear panel off you will see the pump. Be sure to have plenty of towels
& a small container to catch water. I am sending you instructions
from the service manual to remove and replace the pump. Another
possibility is the drain line is blocked or something is stuck in the
tub to pump hose.
Not finding what you are looking for?