20 Most Recent Amana ALW895 Top Load Washer Questions & Answers

0helpful
1answer

No water is coming on at the start of the cycle

check hot & cold hose , take off hose from washer . Put in bucket open water coming or not .
10/8/2017 9:45:57 PM • Amana ALW895 Top... • Answered on Oct 08, 2017
0helpful
1answer

My washer wont drain

Have you checked the drain line?
9/19/2012 6:10:50 PM • Amana ALW895 Top... • Answered on Sep 19, 2012
0helpful
1answer

My dryer squeaks

Hi,
Here is a tip that I wrote about dryers and noises...

It will help you determine what is happening there...

Dryer Repair Squeaks, Grinding, Clicking and Knocking Noise


heatman101

Asker's Testimonial "That answer was very informative - thank you for taking the time to educate me. " - teresa241964

9/4/2010 1:35:13 AM • Amana ALW895 Top... • Answered on Sep 04, 2010
0helpful
1answer

A lot of water leaking out of bottom of washer

You got to open it up to see where the water is coming from. It could be the tub, pump, hoses, anything in there...
5/21/2010 10:06:41 PM • Amana ALW895 Top... • Answered on May 21, 2010
0helpful
1answer

Install belt on Amana top load washing machine

Use the correct sized belt!!

Loosen the Motor mounting Bolts. ( Do not take it off ) Now the motor assembly can be moved towards the opposite large pulley.

Replace the belt in this position and slide the motor to it's original position. You adjust it in such away so that, the belt is not too tight or loose!
4/6/2010 5:35:37 AM • Amana ALW895 Top... • Answered on Apr 06, 2010
0helpful
1answer

Machine will not drain the tub or spin the

your problem still could be a bad lid switch not making. also, check your spin/agitate belt part #40053606. hope the attaced breakdown helps.250
11/8/2009 2:07:04 PM • Amana ALW895 Top... • Answered on Nov 08, 2009
0helpful
1answer

Will spin but not agitate LWA40Aw2

Hi, it sound likes a belt. Some amana washers take 2 belts,1 for the spin,and 1 for the agitate. or some models spin rite of motor,and a belt for agitate. hope this helps. :)
7/7/2009 9:47:38 PM • Amana ALW895 Top... • Answered on Jul 07, 2009
0helpful
1answer

Washing machine squeak

Same squeak on spin -LW8203 shortly before that she ran an off balance load and now wonders why it squeaks..
1/13/2009 3:15:24 AM • Amana ALW895 Top... • Answered on Jan 13, 2009
0helpful
2answers

Rinse light flashing on amana washer

My Amana washer is stuck on rinse
12/21/2021 6:34:47 PM • Amana Washing... • Answered on Dec 21, 2021
0helpful
2answers

Amana washer will not go through rinse cycle

WASHER WILL NOT RINSE: If your washer doesn't go through the washer rinse cycle, the most likely cause is the water valve. What happens is the water valve will stop letting cold water into the washer; therefore, once the washer gets to rinse it will either stop or not do anything during the whole rinse cycle. This is because when you selected your water temperature, you selected warm/cold or hot/cold. The hot water came in and you didn't notice any problems. When it got to rinse, the cold water the cold water won't come in. Therefore, the washer does nothing. To check the water valve, first cut the water off and remove the hoses off the back of the washer. Then one at a time point the hoses inside the washer tub and turn the water back on. If you don't have good water pressure, turn the water back off and remove the strainer that should be in one end of the hose. Inspect the strainer to see if it is stopped up, clean it and reinstall it. Now repeat this test. If you have good water pressure now, reinstall hose and your problem is fixed. If you still don't have good water pressure, the problem is in your house plumbing and you need to call a plumber. If you had good water pressure the first time you performed the test, the water valve is bad and needs replacing. TIMER If your washer doesn't go through the washer rinse cycle the timer may be the problem. Sometimes the timer gets stuck in the middle of the cycle or won't turn at all. If the washer runs, but the timer doesn't turn, the timer is bad and needs replacing. Do you have anti-flood hoses leading to the machine. If you do there is probably a loose tube in the back causing a small leak. When the hoses detect that water is still flowing after a certain amount of time due to the leak it shuts down and causes the machine to turn off during the rinse/spin cycle
12/4/2021 5:32:47 PM • Amana Washing... • Answered on Dec 04, 2021
0helpful
1answer

Looking for a repair manual for a top loading washer, Model No. ALW480DAW

https://www.servicemanuals.net/AMANA/ALW480DAW-SERVICE-MANUAL/1499937/detail.aspx
8/22/2021 6:31:35 PM • Amana Washing... • Answered on Aug 22, 2021
0helpful
1answer

My amana washer is stuck on rinse. Model wtf4506ewo

call a local repair service
8/12/2021 8:19:08 AM • Amana Washing... • Answered on Aug 12, 2021
0helpful
1answer

Amana top loader washing machine with error code F4E1

control board probably
8/12/2021 8:17:17 AM • Amana Washing... • Answered on Aug 12, 2021
0helpful
2answers

Got a Amana model number NTW4605EW0 given to me lid lock switch is gone there is a red,white and blue wire how do you wire it up to trick it to think that the lid is locked

Trial and error I suggest the red and white together should do it. Be careful! You should just buy the switch for the lid mike
7/31/2021 5:22:52 PM • Amana Washing... • Answered on Jul 31, 2021
Not finding what you are looking for?
Amana ALW895 Top Load Washer Logo

Popular Tags

21 questions posted

Ask a Question

Usually answered in minutes!

Top Amana Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8221 Answers

Mike

Level 3 Expert

4379 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1482 Answers

Are you an Amana Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Amana Washing Machines

  • Amana Washing Machines

Most Popular Question

lot water leaking out bottom washer

  • Washing Machines
Loading...