20 Most Recent Tappan 30IN ELEC IGNa Oven - Page 4 Questions & Answers


try putting the stove in self clean when it goes in for about 1 minute cancel the self clean see if it opens.

Tappan 30IN ELEC... | Answered on Dec 06, 2008


stuck keypad or bad clock may come as an assembly.

Tappan 30IN ELEC... | Answered on Dec 06, 2008


does the display light at all? can you hear it beap. sounds like the control board is bad.

Tappan 30IN ELEC... | Answered on Dec 06, 2008


Looks like your oven has a "glow" coil. That being the case, you will not be able to light the oven without power. It has to glow to open the valve, and there is no override for this. Sorry.
About the cord, you could install a plug on the cord, or simply replace the cord. (I realize you say you are trying to get one). Other than this, turkey on the grill is always good.

Mr Boo

Tappan 30IN ELEC... | Answered on Nov 20, 2008


Yes. Igniter stays on from just before ignition until just prior to burner shut down with each burn cycle.

Tappan 30IN ELEC... | Answered on Nov 12, 2008


hi The range timer is usually located in the control panel on top of the range. If you suspect the timer is faulty, don't try to fix it yourself. Remove it and take it to a professional service person for testing. Here's how to remove the timer:

Step 1: Remove the back service panel to the control panel and release the spring clips that hold it in position, or remove the retaining screws.

Step 2: Push the timer forward to release it.

Step 3: Remove the electrical lead wires from the timer housing. If, when disassembling the timer, you notice that the electrical wire terminals look burned, remove these leads and buff the leads and the terminal points with fine steel wool. Burned and/or dirty terminals can cause the timer to malfunction, but a good cleaning can solve this problem.

Step 4: Replace the old timer or install a new one of the same size and type, if this is necessary. Connect the new timer the same way the old one was connected.

Tappan 30IN ELEC... | Answered on Nov 06, 2008


throw the piece of **** out! nobody seems to know how to do this, and there is zero customer service or help available. there are problems like this all over the net with no answers.

Tappan 30IN ELEC... | Answered on Oct 30, 2008



Relighting Your Furnace's Pilot Light

furnace1.jpg - Turn off the gas at the main valve at your utility box - Wait five to ten minutes for gas fumes to waft away - Get a long match—yes, a fireplace match, not a standard match - Set the gas valve on your furnace to "pilot" - Press the red button as you hold the match to the pilot valve - Keep pressing the red button for 30-60 seconds so the pilot can heat the thermocouple. Release the button and see if the pilot remains lit - If pilot goes out, wait five to ten minutes and repeat the process - Once the pilot stays lit, turn the main gas valve back on - If the pilot light continues to go out, call a technician, who may need to adjust or replace your thermocouple or adjust your pilot

Tappan 30IN ELEC... | Answered on Oct 04, 2008


If your cakes are falling you need to cook them longer. The best way to see if they are done is to take your finger and poke the top. If you see the imprint of your finger in the top then it is not done. If the cake springs back to its original shape then it is done. :)

Tappan 30IN ELEC... | Answered on Sep 17, 2008


I tried randomly pushing 2 buttons at a time, and when I pushed "Timer Off/On" and "Cancel" together it unlocked and is now working fine. The following day it beeped a lot for an hour or so (must have been catching up on previous pushes) but now is back to normal.

Tappan 30IN ELEC... | Answered on Sep 03, 2008


My Mod# is on the very bottom of the oven, i had to pull out the broiler drawer to find. It was then on the right side about 8" in on the right.

Tappan 30IN ELEC... | Answered on Aug 19, 2008


check if there are links on the mains connector block and if so, make sure they are tight

Tappan 30IN ELEC... | Answered on Aug 10, 2008


Look for screws to take off perimeter flange then look for screws attaching the oven to sidewalls. It may be a bit of a grunt pulling the oven out.

Tappan Ovens | Answered on Dec 29, 2020


Don't know about your gas oven, but we have a Tappan wall oven (electric) that we want to get rid of. Maybe you could get the door hinges and spring from it? We are in East Tennessee.

Tappan Ovens | Answered on Dec 09, 2018


that ignitor should lite the flame within 40 to 60 seconds if not the ignitor is bad.even though it glows red it doesn't mean it's good it works with amps change the ignitor

Tappan Ovens | Answered on Dec 23, 2017

Not finding what you are looking for?
Tappan 30IN ELEC IGNa Oven Logo

103 questions posted

Ask a Question

Usually answered in minutes!

Top Tappan Ovens Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

john h

Level 3 Expert

23515 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

35811 Answers

Are you a Tappan Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Tappan Ovens

  • Tappan Ovens

Most Popular Question

increase flame only goes half way

  • Ovens
Loading...