Top 20
Frymaster Dean H55 Deep Fryer Questions & Answers
Can anybody tell me what's wrong with this? Any suggestions please and thank you.
The burner or the burner venturi is clogged. The burners are held in place with 2 bolts at the top and you need a 1/2 inch wrench. Remove the bolts and lift the burners off the brass orifices. Make sure all the holes are clear. If they are clogged they need to be drilled out. You should not have yellow in the flames in the burner tube.... kinda looks like the are sooting. This causes flames to come out the bottom of the burners.
Pilot light lights but is a low flame
There is an adjustment screw on the main gas valve, usually under a cover screw. It will be near where the small pipe that goes to the pilot light.
How to clean blocked pilot orfice
One time this happened to me on a gas stove. I used an electric drill with drill bit to clean it out. It will only work if the line is straight, no bends in the line.
Deep fryer pilot is blown out when burners go out
Hi there. Hi limit may be tripping off due to high oil temperature (power supplying the gas valve is connected in series with the hi limit). Verify if the thermostat is not shorted, also please check the thermostat calibration if it is good.
Regards.
Frymaster pump and motor
Hi there.Filter paper may be clogged causing the pump motor to trip-off after the filtration of the second fryer, better scrape off any filtered debris on paper afrte filtering.Also oil temperature must be at least 250F or above to lessen the load on pump motor as oil with low temperature is thicker than oil with high temperature.Regards.
Pilot goes out
problem could be 1 of 3 things a partially pluged pilot orifice a bad therma couple or bad safty on gas valve
Display shows HELP with alarm
The board displays Help with alarm when there no flame on burners during heat demands. Try replacing the gas tanks, gas pressure and volume may be insufficient.
Gas is on pilot won
Hello there: The problem you mention is not that clear. The pilot won't light or the pilot lighted but won't stay on is two different problems. If the pilot won't even light or no gas coming out off the pilot when you push down the pilot button it means the pilot orfice is blocked and what it need is cleaning the pilot orfice. If the pilot light is on but goes off when you release the button then the thermopile need to be changed. Hope this can help.
SR 142 GP, flames shoot out of exhaust stack to
First look down the stack, with the fryer off, and see if there is something that fell down in there. If that is not the case then check to ensure that all of the burners are on when you turn the fryer on. If those check out OK then you probably have soot buildup in the burner tube. Remove the burners and clean out the tubes.
Not finding what you are looking for?