20 Most Recent Sharp AR-5320 Black and White Copier - Page 2 Questions & Answers

Coppy light

Hi,
this is a fuser error message. You must fix the problem causing the fuser to post an error. Then clear the message.

it means that the thermistor in the fusing unit is open which could indicate that it may have become faulty or is because of power fluctuations, a simple crop 14 reset should remove the error, but if it returns it should be looked at by a qualified sharp technichian

Download adriver from support.sharp.net.au and re install your printer with pcl6 driver.

"F5-02 : Exposure lamp blown"

Hi, H4 is a heater error. Try resetting it by the following; Enter #, interupt, Clear, interupt, display goes dead, enter 14 then print. That will clear the error code, however if you have a problem with the heater it will return. It is probably the thermal fuse has tripped, which is resetable by removing the fuser unit

Regards

Andy

Maybe? https://www.youtube.com/watch?v=qchhmaRXTn8

sim 14

go to www.sharpusa.com They have drivers there.

enter sim 14

Copy lamp error Replace the power unit. Check the copy lamp ON with SIM 5-3. Replace the copy lamp. Replace the inverter. Replace the MCU PWB.

enter sim 16

Make sure all the doors are closed & the toner catridge is full

it depends the how the machine was set but normally you can copy up to 50,000 pages

i hope its L4.If it is showing L4 it means the main motor is locked(failing to move) Check all the moving parts including the drum unit, developer unit, main drive unit and fuser unit if they are moving freely. If they are moving freely change the main motor

Enter sim 14 if not help check thermostat in the fusing unit

Copy lamp error, Replace the power unit. Check the copy lamp ON with SIM 5-3. Replace the copy lamp. Replace the inverter. Replace the MCU PWB