Top 20 Toshiba e-Studio 232 Black and White Copier Questions & Answers

Best way to Check is getca status page from your printer ,check the IP address that’s been assigned to your printer via dhcp from the router ,then just add the printer manually by creating a tcpip port with that op address

C260 Scanning system related service call Peak detection error: Lighting of the exposure lamp (white reference) is not detected when power is turned ON. Replace the exposure lamp ..

08>252>0

reset 0+8> 400>0 or change tharmoster

clean side cover charger OR replace it

Toner not loading. If the life copy of the PM parts are stil not over you can adjust the bias 05-205, the charge in grid 05-210 and manual toner adjustment 05-201.

How to reset Toshiba E-Studio 233

Press and hold # button (123)

turn off copier, hold down 0 and 8 while turning it on, when it comes up in test mode press 252, start, o, enter and then turn machine off and on

Might the lift motor is not working, or try to hold the tray pressing in and wait, you can hear the lift motor sounds and stops if not your lift motor assembly is failed it can be repaired.

replace toner chip

Peak detection error: Lighting of the exposure lamp (white reference) is not detected when power is turned ON.

08>205>0 is invalid

Hi Edward Most of the toners cartridges come with un-packing instructions hence read them carefully and also try to clean the chip and also the pins connecting the chip inside the printer to make sure they are not dirty and creating this problem. USE A DUMP CLOTH TO CLEAN

your developer is weak or check tonar detective sensor

what is call service tell me then iwe gave you soloution

search google

U have to buy Printer kit

Lubricate registration clutch, and clean feed rolls with wet cloth.Hope the answer.

lubricate registration clutch, and clean feed rolls with wet cloth.