20 Most Recent
Toshiba e-Studio 232 Black and White Copier - Page 7 Questions & Answers
C440 problem and wait
If 1st time occur, u can just go to 08-400, reset the value to "0" then restart the machine. When this code not cleat 08-400 then check these all thengs.. 1.Check the thermistors (1) Check if the connectors are disconnected. (2) Check if the main and edge thermistors are in contact with the surface of the fuser roller properly? (3) Check if the harnesses of the main and edge thermistors are open circuited. 2. Check the IH board and IH coil (1) Check if the IH coil is broken. (2) Check if the connector of the IH coil is disconnected. (3) Check if the thermostat is blown. (4) Check if the connectors on the IH board are disconnected (AC input connector and LGC I/F connector CN455/456). (5) Check if the IH board or the switching power supply unit are abnormal. • Replace the IH control board. 3. Check the LGC board (1) Check if the connectors CN316 are disconnected. (2) Check if the conductor pattern on the LGC board is short circuited or open circuited. (3) Replace the LGC board. Thanks
Dirty pages
DP unit problem OR charger problem replace it
Leaves black marks on copies
It could be leaking toner from the recovery area that sis on top of the dum, it removes any toner that was not transfered to the paper. You would have to remove it and empty out the toner.
Toshiba resert code
turn off then back on while holding down 0 and 8 keys for more than 10 seconds.............good success, meder's tv service
Not finding what you are looking for?