20 Most Recent Nortel 1140E - Page 2 Questions & Answers

default password 26567*738

First I will suggest you to upgrade the Firmware....check the ringer tune and volume is OK ... or try pressing Feature key * 6 and Press 1,2,3,4 or next to hear different type of ring types .....Press OK to save it....Now Try....Further result please let us know...Thanks for being with Fixya....Good Luck

If you are running C6E or later firmware, then the following keypad sequence is used to reset all provisioning paramaters to a "factory default":
[*][*][7][3][6][3][9][MAC][#][#]
Where MAC corresponds to the MAC address of the IP Phone which can be found on a label on the back of the IP Phone.
Since a MAC address can contain the letters A-F, then letters A/B/C can be entered via the [2] key on the dialpad, and letters D/E/F can be entered via the [3] key.
For example, an IP Phone with MAC address 00:19:E1:E2:17:12 would be reset to "factory default" when the sequence **73639001931321712## is entered on the keypad.

is it a bcm 50?bcm 50 must be version 3.0 release for module to work.

Is it the only IP phone? Howstable is the network?

https://youtu.be/AWsEpWfGp5k Here is the detailed link.

Hi, Nortel will have a phone number that you can dial from any other phone to retrieve your messages.

It looks like this is possible see the manual. https://btbusiness.custhelp.com/euf/assets/TelephoneSystems/BCM/BCM4/CallDetailRecordingSystemAdministrationGuide.pdf

Remember to hit "Feature" first. Dialing **7827887 by itself does nothing.EG;1 - Feature **7827887 (STARTUP) 2 - Enter installer password 266344 (CONFIG) 3 - Change to template desired (square, hybrid, or PBX) 4 - Press NEXT to apply the templateEdit: Make sure you have access to the phone pool as admin and that there are no restrictions set on the phone itself. The same thing was happening to others and was detailed herehttp://www.tek-tips.com/viewthread.cfm?qid=983869