20 Most Recent
Sansui DTV2760 27" TV - Page 5 Questions & Answers
I was watching a DVD
Have the unit unplugged for a while and plugged it back later.
If it resolves your problem and goes back again,
you may have a Video Circuit problem from the
CRT Board, could be a cold solder joint on Green Out
Drive , CRT socket or from the Jungle IC that
drives the Green Video Out
Transistors
Our remote for 21" tv is not working. pl. give us
If you are in Mumbai, get down at Mumbai Central Rly stn. The electronics market is close by. Show the old remote and get
a similar remote. It may not cost more than Rs. 120/= . Price may vary place to place.
When I connect DVD playercables
Make sure you are matching the colors properly ie a yellow cable can only go into a yellow hole---not a green one and etc. It could be the cables themselves if you are matching colors exactly or it could be the dvd player itself of the television (not likely).
Setting up 2nd television for dish network
You have to check the modulator setting (menu 6 1 5 ) if tv 2 is set for air then tv needs to be on 60 cable it is 73. check tv2 if it goes to 73 and the modulator is set for 60 change modulator to cable 73 and tv should work fine
Starting problem
I can't say enough about bad capacitors.I have not repaired this particular model,But I will tell you this. This brand of TV is manufactured with under sized capacitors. They are are small and rated at 85 degrees. If you have a cap checker you can find these. There are about 8 or 9 bad caps here. Half may be located near the vertical IC. The rest in the horizontal section and may be the standby circuit! I would replace them with a high temp cap at 105 degrees and with the same Microfaret and voltage. Good Luck and thanks for asking!
Vertical Hold circuit?
that is usaually a component in side the board called a capacitor that bursts due to high voltages passing thru it. so u will need a technician to replace it for you at a cost
Not finding what you are looking for?