20 Most Recent Canon imageRUNNER C3220 Color Copier - Page 3 Questions & Answers

The only way for you to resolve this problem is to access the yellow laser motor. Unfortunately, you need to remove the laser and check for rotational operation and replace if necesary. That's it - no one can do that for you but you.

*28* the check the toner hopper if tis stock the toner or the connector check the developing unit and the toner ic then after reset all

The error code has to do with the fuser unit. Try to reset the error code in service mode. If that will not clear it, you will need to replace the fuser unit...... Good Luck

your fixing assy. is bad replace it

A E00804 means that a fan is not working correctly. Check all the fans for correct operation.

This is the proceddure for all the digital copiers that Canon has. Press the additional function key, then press 2 & 8 at the same time, then the additional function key again. Screen should now indicate COPIER and any other accessories of the copier. Press the needed item, then across the top should be a series of items that you can change or look at for different needs. Be careful in this area because settings could be changed and then the copier could be dead in the water and all the stuff will have to be inputted from the start.

You have a faulty fuser unit that needs replacing. The fuser unit is the unit that gets VERY HOT in the left drawer section. Two screws either end of it removes it. Check that there is no paper caught inside it causing it to overheat and then, when you put the machine back on you will have to reset the error code in engineers mode. Resetting the code may get you out of trouble for a while. To do this press the following buttons in this order:

the 'head' (a head with a star symbol inside) then hold down the '2' and '8' keys at the same time - then press the 'head' key again quickly - this will get you into service mode - press 'COPIER' then 'FUNCTION' then 'CLEAR' - now press the top selection 'ERR' followed by the 'OK' on the bottom left of the screen. Now turn the machine of by the power switch and wait 10 seconds. Power up now and if you're a lucky one, you'll be back up and running but for how long I don't know. Maybe 5 mins maybe 5 months.

Good Luck

- clean the laser units glass with the special cleaning tool provided with the copier - check and clean the image transfer belt blade and the recycle mechanism- check if the tinting is on the imaging unit , if yes change unit if not chevk above