20 Most Recent
Magnum DeltaForce CB Radio - Page 4 Questions & Answers
My backlights are not working cant see channels at night .
The easy way is for you to get a meter find a good ground, where the coax enters in the back would be a good spot and locate one on your own instand of someone telling you and you miss understand and do harm upon your radio.
5/8/2010 12:33:29 AM •
Magnum...
•
Answered
on May 08, 2010
My backlights are not working cant see channels at
There is a small voltage regulator on the board that the lights mount on, behind the faceplate. It's probably bad. You can isolate the voltage supply on that board and run 12 volts to those traces. You'll need to do some reconfiguring to keep the 6 volt bulbs but you can forget about the bad regulator when you do that. Be very caeful to ISOLATE THE TRACES From ANY Other Traces. If you foul up, Poof!
4/27/2010 9:14:06 AM •
Magnum...
•
Answered
on Apr 27, 2010
How to wire roadking56 for cobra
have you tried cbtricks.com they have alot of wiring codes for cobras... hopefully that helps you.. looked through my wiring codes and cant find it sorry..
4/19/2010 2:29:12 AM •
Magnum...
•
Answered
on Apr 19, 2010
D-104 mike wiring
Go to cbtricks.com look up radio information go to magnum use the wiring set up for the 357.
12/14/2009 7:49:58 PM •
Magnum...
•
Answered
on Dec 14, 2009
How to set the radio to talk
vol set to audio level you like.
squelch set fully counter clockwise
rf gain. set fully clockwise
rf power around the 8-10 oclock position. too much deadkey will give weak audio.
not sure what band it needs to be on.been awhile since playn with this model.
clarifier set 12 oclock setting.
talkback just to were it doesn't squeal or lower
12/8/2009 6:10:27 PM •
Magnum...
•
Answered
on Dec 08, 2009
Not finding what you are looking for?