20 Most Recent Kyocera Copystar CS-1820 Black and White Copier - Page 3 Questions & Answers

Fuser error. Replace the fuser and reset the error. Firmware update is highly recommended.

call for service c6000

6000 error. Broken fuser heater lamp wire The fuser temperature does not rise after the fuser heater lamp has been turned on

error 1105 is E-mail The SMTP protocol setting is turned off. Use Command center and turn on

check the connection on the computer and try it agian.

SIM 163 Reset (only do this one SIM, by doing others you could cause your machine to no longer function. Also see note at bottom.

Entering Simulation Mode

1. Press the system menu/counter key.

2. Select Service setting using the up/down cursor keys.

3. While pressing the start key and the # key, press the enter key. (Maintenance mode is entered.)

4. Select Maintenance mode using the up/down cursor keys.

5. Press the enter key.Enter the maintenance item (163 Resetting fuser problem) number using the up/down keys.

6. Go to step 1 under method below.

Resetting the fusing problem data Description

Resets the detection of a service call code indicating a problem in the fusing section.

When a service call concerning the fusing section occurs, turn the power switch off and open the front cover.

Then, turn the power switch on and press the system menu/counter key to enter the maintenance mode.

Method

1. Press the enter key. A selection item appears.

2. Select Execute using the up/down cursor keys.

3. Press the enter key. The fusing problem data is initialized. (Four service calls, namely C6000, C6020,C6050, and C6400 are reset.)

Completion

Press the back key. The indication for selecting a maintenance item No. appears.

Note: Sometimes in order to do the reset when the machine is in an error state you need to open the top cover (like to replace the toner) and leave it open until you have performed the reset.

scan yo pc use file scan uitility , make sure you install that program, configure it, it seems you did not configure the folder where the scan has to go, so you go this error. I’m happy to help further over the phone at https://www.6ya.com/expert/mustafa_06f84c65ab5cc745

Hi

Error C6000 is displayed when your machine fails to reach the correct temparature at a specific time.

This is a Fuser Unit Problem, try to reset it by--

First open top cover then turn on power.
press system menu/counter
arrow down to service
press and hold start, # then enter keys
arrow down to maintenance
press enter
arrow down to Sim 163
press enter
select execute
press enter
turn off power then back on

If the reset doesn't work then get your unit checked for fuser unit and fuser unit heat issues.

Please do rate this solution as FixYa and revert for further assistance.

Thanks
Rylee

I think Change the SMTP port from 25 to 587 hope i'm right

On the screen of my KM 1820 copier Kyosera get the message "An error occurred calling a technician" and C 7980how I can fix this error?