20 Most Recent Icom IC-R5 Handheld Scanner - Page 5 Questions & Answers

Go to https://www.mods.dk/manual.php?brand=icom and look up the service manual. All the info is there.

When a device or appliance doesn't behave as per the instructions there is little doubt that it is faulty. Whether the item should be repaired or replaced depends on various factors, though it is worth contacting the manufacturer in case there is special advice they can offer.

uk-repair.com/repair/hard-reset/icom-radio-marin-ic-ssb-m802/369/6891.html Try this site

Answer is yes. Look up your local Icom dealer. They mostly are small communications companies (not big box stores like Best Buy etc) used to dealing with commercial customers but happy to see personal walk in customers too. I would expect charge for basic programming to be around $50 - $60. Regards John

Good info posted by Mike Nadeau - N1EQ http://www.n1eq.com/icom-ic-746756pro-series-failure-of-remoteci-v-port/

Hi Yanielki, You want to interface a IC-A110 mic with what other piece of equipment? Are you looking for a wiring diagram? What's the problem? Explain more and myself and plenty others would be happy to help. Regards, John

https://www.youtube.com/watch?v=8W4ntoOWZ-s

Sorry we have no way to look this up.

Hello, You will need the service manual to be able to do this and you will also need to purchase a 150 ohm carbon film resistor (no wire wound resistors) to simulate a 3:1 SWR to reset the onboard auto tuner base line for SWR. I believe you may find a service manual on BAMBA's website to download for free. The auto tuner is factory set to work up to a 3:1 SWR before it gives up trying to match the antenna. So, this is a resistor you will need or make up a 150 ohm load using a combo of resistors as long as they are not wire wound types. 73, Dennis

I usually replace all of my radio lamps with Ultrabright LEDs. They come in many different colours and usually fit the same mounting hole as the incandescent lamps. They will need a current limiting resistor in one of their leads, 2200 ohms to 4700 ohms at 1/4 watt works well. Leds are polarized so make sure that you get the polarity correct. Leds are also about 1/10 the cost of a similar incandescent bulb.

Here's a FREE software program for your ICOM. It is called CHIRP... just google it. I use it a lot.... chirp.danplanet.com

check external speaker jack and internal speaker

some thing loose please check throughly

check at mods.dk site

Adjust the Squelch level

Check PTT when you press it it must ground PTT voltage if it not ground the voltage then replace the PTT switch.

See in programming and enable usb function.