Top 20 JVC KD-NX5000 Car Video Player - Page 8 Questions & Answers

Memory (+12v Constant) Yellow
Ignition (+12v Switched) Red
Ground (-) Black
Power Antenna Blue
Amplifier Power-on signal Blue/White
S p e a k e r s
Right Front (+) Gray
Right Front (-) Gray/Black
Left Front (+) White
Left Front (-) White/Black
Right Rear (+) Violet
Right Rear (-) Violet/Black
Left Rear (+) Green
Left Rear (-) Green/Black

hope that helps.

JVC Car Audio &... | 38 views | 0 helpful votes

Try the jvckenwood website. Or a quick foogle search should turn up numerous places to get it from

JVC Car Audio &... | 103 views | 0 helpful votes

It seems the radio is on demo mode. Press the source button continuously till the radio comes to ''on''. If that does not work press the control button continuously.. JVC 0910DTSMDTJEIN Instruction Manual Basic Operations

JVC Car Audio &... | 207 views | 0 helpful votes

Run the speaker wires from the stereo to the amplifier high outputs, or get a converter fr your stereo speakers wires to rca, most older amps have a high output witch have a left +-, Right +- depends on how many channels your amp is..

JVC Car Audio &... | 255 views | 0 helpful votes

Due to liability the video cannot play unless the e brake is on. This assumes the unit is connected properly. There is one wire in the radio harness that is connected to the ebrake switch. There are ways around this safety feature however their are laws in most areas making this *******.

JVC Car Audio &... | 140 views | 0 helpful votes

Sounds like you have a speaker wire shorted or touching. Pull stereo out of Dash But leave wiring harness plugged in. With stereo off unplug positive and negative of one channel or speaker then power on to see if it starts to work. If it still says protect shut back off wire that channel back up and go to the next Channel. As you do this one speaker output should be the culprit. If you go through all 4 and it still says protect then it may be a problem within the unit itself

JVC Car Audio &... | 256 views | 0 helpful votes

If you wish to buy its original remote control, contact the authorized service centre, or authorized dealer to your device brand. They can either give you a genuine remote control to your device, or can direct you, from where can you purchase a suitable one.
To select a proper universal remote control, you should know about the number of digits to its set-up codes. There are 3 digit, 4 digit, 5 digit, 2 digit and even single digit codes, to some brand devices. After confirming this, check the sites linked here. Both the sites have set-up code list and set-up procedure to many popular brand remote controls. Check which brand remote control has set-up code/s to your device brand, and buy that one according to availability. Brand name of the remote control isn't a matter, but it should have set-up codes in its code list, to the device brand you have.
Please note: Every new universal remote control will have set-up code list, and set-up procedure along with its pack. Never accept a remote control, that hasn't both of this. For more details about the set-up codes, visit the sites.
Universal remote controls are available at most of the electronic spare part selling shops. Visit some on-line sites too, which deals with electronic spare parts.

JVC Car Audio &... | 144 views | 0 helpful votes

You will need to order a replacement factory remote. Universal remotes only operate home equipment. The chances of finding one that happens to have the codes for the car unit are slim and there is no crossreference for them. Ebay is a good source for them.

JVC Car Audio &... | 135 views | 0 helpful votes

Any style of TV antenna will work. Rabbit ears too.

JVC Car Audio &... | 90 views | 0 helpful votes

Repair cost would exceed replacement cost. Try disconnecting all the speakers and see if it works then. Try reconnecting each speaker by itself and see if that causes the problem. Most grand am have the monsoon sound syatem...even if they aren't labeled as such. Pull the carpet in the trunk on the left (drivers) side wheel well. The monsoon amp is located over the wheel if you have a monsoon system. If you have to remove the amp then you must change the speakers out or rewire them as the monsoon system uses bi amp speakers. Most of the ga forums have extensive write ups on this system.

JVC Car Audio &... | 47 views | 0 helpful votes

A new harness is available online at nearly every retailer. Amazon, ebay, metraonline, eyc. Connecting wires to the pins without any accidental shorts is difficult at best. Spend $10 and get a new harness.

JVC Car Audio &... | 115 views | 0 helpful votes

This should be the link to the instruction book for your unit, Its in a pdf file

JVC Car Audio &... | 594 views | 0 helpful votes

If you are trying to watch a dvd while driving (which you shouldn't) and without setting your parking brake then you'll need to ground the parking brake wire in the harness for your head unit.

JVC Car Audio &... | 954 views | 0 helpful votes

The wiring guide for the KS-S29J is on page 2 of the installation guide. This is available on the JVC support page. Start at and enter the model number. The direct link to the installation guide is . The direct link to the owner's manual is .

I hope this helps.

Cindy Wells

JVC Car Audio &... | 1,361 views | 0 helpful votes

The KD-R504 does not offer Bluetooth functionality.... Sorry.

JVC Car Audio &... | 261 views | 0 helpful votes

Not finding what you are looking for?
JVC KD-NX5000 Car Video Player Logo

Popular Tags

24 questions posted

Ask a Question

Usually answered in minutes!

Top JVC Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

5023 Answers


Level 3 Expert

85239 Answers

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers

Are you a JVC Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

JVC Car Audio & Video

  • JVC Car Audio & Video

Most Popular Question

jvc kd nx5000 not working properly

  • Car Audio & Video