20 Most Recent
Logitech X-540 Computer Speakers - Page 6 Questions & Answers
None of the speakers in the shystem work.
Hello there!
Well, here we got a few things to check
1) Type os sound card you got, 5.1 , 6.1 7.1??
2) Depending on your system windows Xp or Vista? adjust in control panel , the speaker mode, for above configutarions. example: for 5.1 surroung sound .
3) verify if you on bios disable the on board sound, back conections , and the mixer is enable, and nothing on mute. **
that's it!
Open Sky
My pc speaker volume keeps fluctuating
Most likely the potentiometer is used. If it's a cheap speaker set just buy a new one otherwise you will have to open the speaker case and replace it. Even if you succeed in fixing the potentiometer, it will be borked again very rapidly.
Can 2.1 pc speakers work thru headphone jacks?
No it's not possible to have a sound. Because the HDMI and the Headphone (3.5mm jack) are on two different technologies.
The monitor does not have a way to convert the sound from HDMI to Headphone.
There could be a converter that might convert the sound signal from HDMI to headphone (but I'm not sure).
I pluged 110w system into 220 i hate to throw
I think you mean 110 (or 220) volts, not watts (w).
Whether it can be repaired is very dependent on the protection Logitech provided on the AC input.
Because of cost, it is pretty primitive but it wouldn't hurt anything (anymore) to gain access to the innards and check to see if there is an internal fuse that you can replace.
If you see signs of flashover (burned areas) the unit is probably junk.
Logitech X-540 limited sound
why dont you have them all hooked up? I have the same speakers but I the model that only has 2 speakers. Try pluging your audio cable in the front where you would plug head phones in. Assuming that this is a desktop.
Can I have my Logitech X540 Speaker system thru my tv
HERE is a link to the Z-540 manual. It should help. Connect the green plug from the audio input cable to the "line out" jack on your TV. Do NOT use the black or orange plugs. WIth a 2 channel card like your TV's you will not get sound from the rear speakers unless you enable matrix mode through the remote.
Hope that helps!
If your issue is
not resolved, please do not assign a rating just yet. Please post back as
to what steps you took, results, etc, and I will try to assist you further as
best I can. I am here at your service.
P.S. - You can rate a solution with one of four
ratings as explained under (remember that at times a bit of to and fro dialogue
may be necessary to resolve an issue).
- "FixYa!"
- The solution provides great advice on how to solve the problem.
- "Helpful"
- The solution provides useful leads that helps solve the problem.
- "Thanks
for Trying" - The solution does not solve the problem but the
effort is appreciated.
- "Inappropriate"
- The solution has absolutely nothing to do with the problem.
Thank you for using FIXYA!
IrishDruid
Speaker static when volume is changed
There is dirt or corrosion on the track of the potentiometer for the sound
One test is to rapidly turn it full on and off about a dozen times (with the unit powered down ).
If there is anything on the track that sometimes shifts it or polishes the track clean
Proper fix is to get a tin of switch cleaner with a lubricant in it such from Tandy or Maplins take off the knob and spray a good dose down between the shaft and the retaining nut.
Give the knob a few good full rotations and check it out
If that does not work you need to remove the covers to get access to the potentiometer to get some cleaner inside it
How to connect Logitech X-540 to a laptop
buy a usb 2.0 type soundcard because your laptop does not support 5.1 surround speaker here is the link that will solve your problem http://www.amazon.com/Zalman-ZM-RSSC-External-Sound-Card/dp/B0001OZ2K8
Logitech x-540 speakers cord
went somewere that gave me a simple answer for free....No money wanted i called they told me were....Yea and did i say it was free...Didnt cost me a dime....You guys are a joke....19.99 for chat and 9.99 for premium lol.. will never use you people again...and the funny thing is that you would have not known the answer or at least been honest about it.. Oh and no thanks for your pitiful help...
Sound is Pulsating when music plays
Ahh, I have these speakers and its common when you have the volume knob turned all the way down, to fix it, turn the volume REALLY low in windows, so that way you have to turn the volume knob on the speaker control up to 50-100%. And you will have better sound..... No pulsing
Need replacement sub box
Go to nearest computer store, ask them if they can give you the address of Logitech service center in your area.If one store does not help, go to 2 -3 more.
Another option , try searching in google maps for logitech service center in you area, this might sound stupid but works in some cases.
How does Logitech X-540 speakers connect to a laptop?
see it is a 5.1 speaker system if your laptop comes with 3 audio jacks with colours green black and pink then all your speakers works if you have only two jacks tht is one jack for audio and other is microfone then u only your woofer and 2 speakers works in speaker cables ther will be two cables connect the green one to green jack your sound plays if u have totally 3 jacks connect the 2nd cable to black one(non microfone jack)check this out this works
Not finding what you are looking for?