20 Most Recent Karcher 2500 PSI Pressure Washer - Page 8 Questions & Answers

hondas are gravity feed no pump needed .You might need to clean the card though.

at the base of the engine

let it idle down after using it then shut it off the carb could be leaking a little with the bad fuel we get only lasting 30days i always turn off the gas and run the gas out of the carb

pure luck

at the bottom of engine you will notice a plug take it out and oil will draine out .... replce it then fill at top where u see oil dipstick

the adjustable wand or pressur regulator may be clogged with rust inside. it's economical to replaced the wand assy.

check the impellers, may need replaced

most auto stores have high pressure connectors and or machines
to make these connections. Also there are radiant heat connectors
that may or may not fit.

Usually electric pressure washers only have oil on the pump, so its very likely that you will find the problem there. I'd say check all the pump seals and if that doesnt solve the problem, you can check to see if all bolts are tight when you close the pump back.If by any chance you are looking for a new machine and/or parts for your machine, log in to www.roncoshop.com where you will be able to find pretty much anything for your preassure washer.

I found that by putting the housing in the freezer for a couple of hours, i was able to tap the metal and plastic body apart and install the new inlet elbow.

Karcher Model G2650 OH with Honda 6.0 HP, GC 190 Engine. Engine won't start. New gas, has spark. Seems to flood instantly. Much gas in cylinder. Spark plug wet. Choke pulled out, power on. Oil OK. released pressure in line. Where can I down load a Honda Engine manual! Thank you !