20 Most Recent Black & Decker BDL500S - Page 7 Questions & Answers

0helpful
1answer

Outside temp read 80.Smart phone weather said 70.Replaced batteries and did all the troubleshooting. Model 0041/00609SBDIA/00611A3. Less than 1 year old. Inside temp works, dashes on outside reading.

Place your remote temperature sensor and the inside unit together for about an hour to see if they both read the same or if there is a large difference in the temperatures.Dashes on the outside temperature reading may indicate that the inside unit is not receiving a signal from the remote. Change the batteries on the remote or change the location of the inside and/or outside units so that they can receive a strong signal between each other.Your smartphone temperature may be coming from a location that is not near your home. They are often from a weather service. Where is your local temperature sensor located? Is it in the sun? Is it on the south side of the house, or another location where the sun or an air conditioner or other heat source may affect the accuracy of the reading? Try to locate your outside sensor in a shaded location with plenty of ventilation, and away from heat sources.
9/7/2019 4:08:42 PM • Measuring Tools... • Answered on Sep 07, 2019
0helpful
1answer

All of thes answers refer to watches.My product is a weather station Auriol Z29962D The time is always 1 hour ahead.If I set the time manually,it will eventually go to 1 hour ahead of BS time or 2 hou

Do you have a setting for the power line frequency? Some devices get their timebase from the power line frequency and if your powerline is 60 Hz, but you have it set on 50 Hz, then it will speed it up because of the 10 extra cycles per second.
9/7/2019 3:56:40 PM • Measuring Tools... • Answered on Sep 07, 2019
0helpful
1answer

Auriol weather station. My external sensor is not working. I have replaced the batteries but it still doesn't illuminate the red led. Please can anybody give me advice

The sensor should flash briefly when you put in good batteries. Afterwards it should flash about every couple of minutes. If you have a voltmeter check the batteries are at least 1.3 volts (the voltage will drop when they get colder). Ideally they should be about 1.4-1.6 V. Try cleaning the battery compartment contacts and springs with a cotton bud and alcohol. If the contacts look rusted then use fine emery paper or scrape with a screwdriver to remove the rust and tarnish. Clean the ends of the batteries by rubbing with a tissue or cloth. When inserting new batteries twist them inside the battery housing to help make better contact. Another thing you might try is to use a screwdriver to very carefully stretch the springs in the battery compartment a little to allow better contact. (Warning do not pull the spring too hard so as not to damage it) If using new batteries does not help then the sensor may have a fault. If the led on the outdoor sensor is flashing but the indoor sensor does not pick up the signal you can try putting the indoor sensor closer to the outdoor sensor. Otherwise you may need to re-tune the indoor sensor to the correct frequency (there is a small adjustable screw inside).
8/31/2019 5:35:14 PM • Measuring Tools... • Answered on Aug 31, 2019
0helpful
1answer
0helpful
1answer

Sokkia SET630RK3

last four of phone no.
8/24/2019 3:24:58 PM • Measuring Tools... • Answered on Aug 24, 2019
0helpful
1answer
0helpful
1answer

I have a Model WS-8119U-IT clock-indoor/outdoor thermometer. It doesn't show outside temp. The model of the transmitter is: 10N10. Can I get a new transmitter?

Radio Frequency communication may come and go occasionally. This can be normal in some environments (e.g. moister climates). If transmitter signal is lost, please wait 2-4 hours for the signal to reconnect on its own. Here is a link to the User Manual for your product. https://www.lacrossetechnology.com/media/catalog/product/w/s/ws-8119u-it__faqs_1.pdf
8/18/2019 2:34:32 PM • Measuring Tools... • Answered on Aug 18, 2019
0helpful
1answer

Auriol weather station

Hi Bogdan. i think the LCD is not good. if it is possible to replace it??? regards. nuwan
8/15/2019 1:55:12 PM • Measuring Tools... • Answered on Aug 15, 2019
0helpful
1answer

How can I be able to reset my fluke digital multimeter to defaults since when measuring I get very different readings the model number is fluke 111

try new test leads first. even if the unit is miscalibrated, you should get the same measurements from the same components/circuits. you'll need to send the unit to a calibration center, or the manufacturer, to get it zeroed out, if you still need to afrer getting new test leads
8/13/2019 10:15:29 PM • Measuring Tools... • Answered on Aug 13, 2019
0helpful
2answers

How does a leak detector work?

Here is your answer: http://plumbr.eu/blog/how-do-leak-detectors-work-plumbr-case-study
7/22/2019 6:01:01 AM • Measuring Tools... • Answered on Jul 22, 2019
0helpful
2answers

When does spring start and finish in italy?

March April and May
7/20/2019 7:24:55 AM • Measuring Tools... • Answered on Jul 20, 2019
0helpful
1answer

Looking for a user manual for optical tape measure M 100 by Ranging Inc.

Tape measure and manual for sale on eBay. https://www.ebay.com/i/113701075337?chn=ps
6/24/2019 11:59:25 PM • Measuring Tools... • Answered on Jun 24, 2019
0helpful
1answer

I have a new DM 4100 by Sperry and can't get the back open to change the battery....It is stuck or I don't know what I'm doing.. Jim

1. Disconnect the test leads from any energized circuit and then from the instrument. 2. Turn the range switch to the "OFF" position 3. Slide off the back case battery cover. 4. Remove the battery from the compartment and unsnap the battery connector. 5. Replace the battery with a 9V transistor type battery (NEDA # 1604), For maximum battery life, alkaline cells are recommended. 6. Reverse the above procedure to complete replacement.
6/15/2019 9:23:30 PM • Measuring Tools... • Answered on Jun 15, 2019
0helpful
1answer

I have a model 01536/8900123 weather station that will not record rainfall anymore. I replaced the batteries and checked for any blockages. weverthing else works fine.

Have you tested the rain gauge using the calibration procedures on page 21 of the manual? Specifically confirming that the bucket is emptying about every 25 drops. https://www.acurite.com/media/manuals/01536-instructions.pdf
6/6/2019 3:28:12 PM • Measuring Tools... • Answered on Jun 06, 2019
0helpful
1answer

How can I turn off the alarm on my weather station. It seems to go off when it starts to rain.

no info -generic answer check with manufacturer -owners manual online search uging make and model of mystery unit
6/5/2019 12:39:50 PM • Measuring Tools... • Answered on Jun 05, 2019
0helpful
1answer
0helpful
1answer

Next 30 Days Weather forecast for Semonkong Lesotho.

check Google weather, or check environment Lesotho weather station. :-)
6/2/2019 11:49:22 PM • Measuring Tools... • Answered on Jun 02, 2019
0helpful
1answer

How to set scales at zero

Depends on the make of the scales. Check manufacturer.
6/2/2019 11:47:38 PM • Measuring Tools... • Answered on Jun 02, 2019
Not finding what you are looking for?
Black & Decker BDL500S Logo

Popular Tags

1 questions posted

Ask a Question

Usually answered in minutes!

Top Black & Decker Measuring Tools & Sensors Experts

Brad Brown

Level 3 Expert

19165 Answers

Tom Chichester

Level 3 Expert

62329 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

53409 Answers

Are you a Black & Decker Measuring Tool and Sensor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Black & Decker Measuring Tools & Sensors

  • Black & Decker Measuring Tools & Sensors

Most Popular Question

instruction manual

  • Measuring Tools & Sensors
Loading...