HP LaserJet P3005 Printer - Answered Questions & Fixed issues

clean the drum of the toner with tissue paper and reinstall hopefully it will resolve the issue

Hi Adam,
I suspect that you are talking about the tray 2 pick up roller. Here are the directions for that:
1.)Remove paper tray
2.)Unlock left locking tab and rotate forward untill bushing slides off
3.)Remove black plastic roller retaining bracket
4.)Slide roller to the left untill right side of shaft clears the bushing
5.)Lift roller out of printer
6.)Place spring loaded end of roller shaft into left housing
7.)Slide roller to the right and rotate until roller locks into pickup shaft
8.)Reinstall black plastic roller retaining bracket. Left side first.
9.)Reinstall left bushing and lock into place

Let me know if you where sucessfull,
Printer Piete
www.allprotech.com

Please check the cartridges it see if the toner is finish,clean the print head because it may be block up or you can replace it if it is damage.

That sounds like to me that the pick up rollers are not pulling the paper. Replace the rollers.

check cables connectivity otherwise replace the fuser

Try downloading and installing the XP driver from
http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareIndex.jsp?lang=en&cc=us&prodNameId=1846089&prodTypeId=18972&prodSeriesId=1846088&swLang=8&taskId=135&swEnvOID=228

This could be a setting on the printer, in the driver on your computer, or the document you are printing. First, try printing a different document and see if the problem persists. Reset the printer to factory default settings, also referred to as a cold reset. HP has instructions on their website here: HP LaserJet 2300 Printer Series Resetting the Printer Cold Reset You can also go into the printer driver on your computer and reset settings there, or uninstall and reinstall the printer.

Power off and then hold down check mark button as you power up. This resets the paper settings.

Plastic flags in the output bin can get stuck

Toner Cartridge Drive need to be change

Just lift up the Toner Access Door, take out the toner and replace with a new toner cartridge.

Your problem description is not clear, but based on experience I bet that your printer is taking three sheets of paper at a time. The pickup roller in tray 2 and the separation pad in the tray are probably worn out. They are easy enough to replace. You can verify that printer works properly by printing from manual feed tray and if that works ok then above solution is likely your fix.

chek for papers under toner area and check sensors

Check Tay2 paper sensor flag, located at tray2 pick up roller, its its stucked shoot the fault

Try plug the powercord in different outlet. No luck ? Your powersupply i probably defect and needs to be replaced. Contact your local HP repair-shop and have them repairing your product.

there are four black plastic finger type actuators protruding from the exit rollers ( in the catch tray) these help push the paper down after exit from printer - in some cases where damp paper is common the curl generated by the fuser heat is enough to trip these \'Fingers\' into the position where the printer thinks the output tray is full to capacity do you ntoice when the paper leaves the machine if there is any curling in the paper if this is the case open a new ream of fresh paper and try again also the output tray full sensor is probably covered in dust/paper debris- removing the top cover will reveal the position of the sensor connected to the actuator arms clean and dust this to cure error ( assuming theres no damp paper)

in settings remove mirror image.

Could be a Bad NVRAM in the printer, memory went bad if it flashes right away.

Follow this link ,may be it will help you....http://www.hp.com/global/us/en/wireless/printer-setup-help.html

if you haven't any error message then you may have a problem in laser shutter, check and reseat your catrtidge, or you have a problem in your DC Controller