20 Most Recent Kyocera FS-C5030N Led Printer Questions & Answers

LSU cleaning motor error

When the LSU cleaning motor

is driven, an error signal is

detected continuously for 1 s.

Defective connector

cable or poor

contact in the connector.

Reinsert the connector. Also check for continuity

of the connector cable. If none, replace

the cable.

Kyocera... | Answered on May 27, 2019

check the fuser or drum with out seeing the copies its hard to tell for sure

Kyocera... | Answered on Aug 06, 2014

there is a blue mark on the right side of the fuser simply pull it towards you and that should allow you to see the rollers and remove paper if not its four screws and three connectors to remove the whole fuser

Kyocera... | Answered on Jul 10, 2014

please replace cartridge chip

Kyocera... | Answered on May 10, 2014

replce the toner chip

Kyocera... | Answered on May 10, 2014


Toner Box full when its not - fault

Putting a small lump of bluetac on the inside of the door will push the waste toner collection box into the correct position and stop the empty the toner box fault.
As the toner box is not seating in the sensor correctly.

on Feb 13, 2014 | Kyocera FS-C5030N Led Printer

please open drum unit and there you can find a unit called charge unit inside this one thine wire is coming clean that wire and check ...... if you want full details please chat with me ... my ID [email protected]

Kyocera... | Answered on Jun 14, 2013

1. Check that you are using the latest print driver - from kyocera website.
2. If the issue is when you print pdf files then make sure you set the printer in KPDL Auto mode - check the print driver settings about this and the printer menu.
3.You may check if you have the latest firmware installed within the printer - print a service status page (Menu->Others->Service).

Kyocera... | Answered on Dec 12, 2012

you are overcomplicating it... all you need is a compact flash card big enough for the firmware... then you upload the firmware to the card and stick the card into the printer... but first power down printer and plug it out and then turn it on and follow the display... it will prompt you

here is the steps...

you will see ready
then press menu... arrow down to memory card
press forward arrow
you will see format
press enter
you will see processing
when its finished
you will see ready...
turn off machine... unplug it...
pull out compact flash
plug machine in
turn it on...

the **** for the compac flash is on the right hand side at the bottom by the ventillation opening...

I’m happy to assist further over the phone at https://www.6ya.com/expert/norman_d2fa496dce30c65d

Kyocera... | Answered on Oct 27, 2012

Not finding what you are looking for?
Kyocera FS-C5030N Led Printer Logo

72 questions posted

Ask a Question

Usually answered in minutes!

Top Kyocera Office Equipment & Supplies Experts


Level 3 Expert

85239 Answers

George Mclaughlin

Level 2 Expert

369 Answers

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers

Are you a Kyocera Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

FS Kyocera

  • FS Kyocera

Most Popular Question

changed blue toner now prints

  • Office Equipment & Supplies