Top 20 Pelican Products 9430 - Products 9430-B Remote Area Lighting System, Black - Page 8 Questions & Answers

You will need to buy amp meter and check load, however I would replace breaker. If wires were touching the breaker would not reset. Be careful and good luck. Yours would ce a money making job, should go quickly, I would charge $145.00 labor plus parts.

https://www.acurite.com/media/manuals/75100-75127-75152-75155-75159-instructions.pdf

Make and model would be helpful

page 6 and 7 Intelli-Time ® clock and calendar are pre-programmed to the correct time and date, and update automatically for Daylight Saving Time. All you need to do is select your time zone using the "ZONE" button https://www.acurite.com/media/manuals/13020-13026-instructions.pdf

heres the manual on it and it shows how to change that. https://www.manualslib.com/manual/654211/La-Crosse-Ws-9049u-It.html

Go to manual or manufacturers web site.

Check with manufacturer of whatever it is.

We have sokkia total station cx105c giving error code E880 as switch on instrument. Please give a solution

Bar length of what?

You will need to send this expensive meter to Fluke for repair, any Snap-On tool dealer can help.

This website has no rubic cube.

Check eBay or Amazon.

no good complaining on fixya site as we don't make or sell anything far better for you to contact the manufacturer direct

there are no replacement parts on system time for a new one.$29.00 on amazon.

I have no idea what this 1099RX is.

Hi check if you're spark plugs are the correct heat range....check air cleaner try giving the motor a compression leak test if this doesn't work the carburettor probably needs a good clean .cheers.

Hi yes set the dial to 600 on the DC voltage for 275 Volts DC::: 2000m to 600 Volt DC ::::: dial in photo is pointing to DC voltage.:::::::.black 200 to 500 is AC voltage ::::: right hand side is Ohm's resistance .200 ohm to 2000K- Ohm ..1k-ohm=1000.Ohms.....cheers

https://www.davisinstruments.com/resources/weather-monitoring/#support Look for your model number. The issue is setting the ISS to the right channel and then setting the console to find it.

Who makes that unit? A reading of that temperature usually means that the sensor is bad.

Hello, Larry - To answer your question you need to indicate the make and model of your anemometer (the name for the device which measures wind speed.) You can add that information by clicking or tapping on Comment and typing in the information. Perhaps you can find your anemometer here: https://www.grainger.com/category/air-velocity-meters-and-anemometers/air-movement/test-instruments/ecatalog/N-b83 or here: https://www.weathershack.com/category/anemometers.html Best wishes.