Top 20
Akai LCT3201AD 32 in. LCD Television - Page 9 Questions & Answers
Cannt get tv to change chanel
Check the mode the tv is on (Use "Source" button on remote to change modes). There are several modes to choose from.
Power Shuts off after 30-45 minutes
I will say that the part that you bought could have been removed from another LCD and it might not be working properly due to components that become defective when they overheat.
It looks like there are not service parts or they are difficult to find.
Most power supplies I've repaired have components that failed after about 1500 hours of use.
The only way to get the LCD working is to repair the power supply to the component level instead of swapping it.
In about 95% of the time the power board is defective.
Let me know if you need further assistance.
Spares
Check here to get required
main PCB of Akai tv. Hope this will helpful info for you.
Same power issue as the rest...
The majority of these
LCDs have problems with the power supply. Once the power supply is fix, the LCD should work.
I've repaired a few of these power supplies, if you need more info you can email
[email protected]
Power supply
Hi, this was for the TV model LCT3201AD. My TV was about a tear old when the TV went out. It may be that the power supply is out. TIto
Akai LCD 32"
Locate the big mains smoothing capacitor (near the mains input usually) its often 40uf-220uf 400v on 240v mains.
Switch on and test the voltage across this capacitor and expect 300volts or more (320v average uk) or 1.414 times the mains RMS voltage
Turns on them off
It sounds like a defective power supply module that is causing the failure on your TV. In about 95% of the time the power supply fails but there could other failure(s) in the other LCD circuitry.
If you need further assistance you can write to
[email protected]
AKAI LCT3201AD Tv will not
I have just repaired one of these sets for the 2nd time. The problem is definitely the Capacitors on the Main Power Supply Board. If you are handy, you could replace them yourself, or You can send your board to me and I will make the repair for you. Akai initially used what I feel are sub-standard Capacitors on these boards, and I have found that by replacing most of them, this problem can be eliminated. My email address for repairs is
[email protected]
Sharp tv
First do a hard reset by unplugging it for a couple hours, then plug it in and try again to power it on. If no change, or power light just flickers then goes off again, your power supply may need rebuilt or replaced. Try this reset first, post back if no change.
Akai lct3201 ad power supply
The MLT169A is a version number issued by MegaMeet in asia who built the supply. The correct part number for the SMPS for that unit is: E7802-005008 and unfortunately they are no longer available... However, there is some good news, those supplies can usually be rebuilt but you need to have the equipment, knowledge to make the repair...
Bill
Akai LCD TV wont turn on
Hello davidshu,
The issue seems to be a power supply problem. The television has a switching power supply. This might be the problem. I would suggest getting it repaired at a television repair shop due to the possible complexity of the work that needs to be done.
AKAI 27' 1 YR OLD WONT STAY ON
see
http://www.fixya.com/support/t214564-power_supply_burned_up
ordering a power supply from either vancebaldwin.com or partstore.com
Not finding what you are looking for?