20 Most Recent
- Page 9 Questions & Answers
I just had a cable box hooked up to my Audiovox
If the DVD is playing well on the TV then it is possible that the tuner of the TV is faulty.Replace with the same type.If however there is absence of picture even with the DVD then it is possible that the IF section/decorder/AV signalprocessing sections can be defective.
The test to find out the failure of the suspected section is by a voltage check or a signal analysis with a CRO----Since this is beyond the scope of a DIY iwould advise thatyou take help.
Finally take a quick checkfor break of working voltage to the above sections.Check the 12V and 5V rail to these sections.Apossible fusible open resistor regulator in this section must be checked.
8/31/2010 6:40:14 PM •
on Aug 31, 2010
I have an Audiovox VCR
Take a blow dryer and blow dry it ,is one way and another way is to just jump the dew switch with a jumper wirer.
8/13/2010 8:44:02 PM •
on Aug 13, 2010
I have a magnavox flat screen lcd tv. It says the
Now,hook ur tv Air broscasting incommig tv signal.Give it power.Now,tv turn on have picture flashes few sec. than dies just have only sound left?Yes,than the long LCD inverter board is dead.The long LCD inverter board,help the LCD screen to get a baklight to get a picture.Tries websites like shopjimmy.com,Ebay,com to buy a refurbish LCD inverter board for the replacement.
7/29/2010 6:55:03 PM •
on Jul 29, 2010
Need code foe 1900 s
for using FixYa. If after trying all of the codes for your TV,
you still cannot get the remote control to operate your TV then please follow
1. Turn the TV on.
2. On the remote control, press TV once. Then
press and hold Setup until the TV key blinks twice, then release Setup.
3. Enter 9 - 9 - 1.The TV key will blink twice.
4. Aim the remote control at the TV and slowly
alternate between pressing Power and TV. Stop when the TV turns off. A working
code has been found.
NOTE: In the search mode, the remote control
will send IR codes from its library to the selected device, starting with the
most popular code first.
5. Press Setup once to lock in the code. The TV
key will blink twice.
6. To search for the codes of another device,
repeat steps 1 to 5, but substitute the AUX key for the auxiliary device you
are searching for.
Please do accept the solution if the issue is
resolved or post a comment for further assistance.
5/14/2010 9:40:08 PM •
on May 14, 2010
Built in dvd player shows
what type of disc did you insert? was the disc an authentic or burned copy. if burned what format did you burn it in. Did you make sure the disc is the correct region?
3/29/2010 4:13:30 PM •
on Mar 29, 2010
Have a tape stuck in the vcr and machine keeps
You will have to take it apart. Take the lid off, and you should see a gear that you can turn by hand. Turn it until the the tape pops out. It shuts off because it can't get the tape out. Hopefully after you get the tape out that will solve your problem.
3/11/2010 10:27:21 PM •
on Mar 11, 2010
How to my tv in to a computer monitor
It could be easy depending on if you have a PC connection on the back of your TV. If you do you can purchase a VGA cable that would normally be seen on the back of a computer and connect your computer to the TV. Of course, you will need to ensure you have a VGA connection on the back of the computer if its a laptop.
If you don't have a VGA port on the back I've heard you can use an S-video cable but I've never used one.
1/29/2010 8:09:08 PM •
on Jan 29, 2010
Need(lost)a fuse for car power cord for a audiovox
TV/DVD combination unit
1 Left speaker
1 Right speaker
2 Pair of infrared headphones
Wireless remote control
6 "AAA" batteries
ADS-1225PC AC power adapter with attached 6' cord (12 V/2.5 A)
69" Power cord with cigarette lighter adapter (has installed 5A fuse)
7" RCA cable (has left and right RCA audio jacks and an RCA composite video jack on one end and a minijack connector on the other end)
1 Adjustable shoulder strap (has a maximum length of 47")
4 Adjustable mounting straps (each strap has a maximum length of 3')
One 90-degree coaxial adapter (has a 75-ohm coaxial jack on one end and a slip-on 75-ohm coaxial connector on the other end)
1 Storage bag
1 Mounting bag
Product Registration card
12/30/2009 5:27:44 AM •
on Dec 30, 2009
The dvd player built into
Hi, As general guidance, No Disc either means that the format is not recognized. For Example - When you put a R/W disc in an old player or because it can't read tracks. The later can occur if the head needs cleaning with a head cleaning disc. This does not always work!
Has the CD been used in this machine before?
Does it happen to all CD's..then a head clean is required.
You could purchase a Lens Cleaner CD that would help to Fix this issue. Before this, you could also try to switch OFF the Player and then Turn it Back On after few minutes, say 30 minutes and check the progress.
But,More likely it Sounds as the Lens has Gone Bad or there is a faulty Circuit.In both conditions, you need to have a Professional on site as it needs to be dissembled.
Let me know, if needed further assistance.
Hope i helped you.
Thanks for using ' Fixya ' and have a nice day!!
12/8/2009 2:14:02 PM •
on Dec 08, 2009
Not finding what you are looking for?