Xerox Phaser 6110 Laser Printer - Answered Questions & Fixed issues
Phaser 6110 factory reset?
NOTE: Print a Configuration Page before resetting
NVRAM. Press and hold the [Up] arrow button on the Control Panel, and then press the [OK] button. This will automatically display the Service Tools menu on the Display Screen.
- Press the [OK] button.
- Press the [Up] or [Down] arrow button to select [Reset NVRAM], and then press the [OK] button.
To reset the printers NVRAM using the Control Panel:
- Press the [Up] or [Down] arrow button on the Control Panel to select [Troubleshooting] on the Display Screen, and then press the [OK] button.
- Press the [Up] or [Down] arrow button to select [Service Tools], and then press the [OK] button.
- Press the [Up] or [Down] arrow button to select [Reset NVRAM], and then press the [OK] button.
- Press the [Up] or [Down] arrow button to select [Exit], and then press the [OK] button to return to the Main screen.
10/22/2015 11:52:49 PM •
Xerox Phaser ...
•
Answered
on Oct 22, 2015
•
623 views
How do i adjust heat settings in xerox 6110
If you tried to print on a transparency sheet for ink jet printers, in your laser printer, you could have damaged the heating rolls. The plastic could be molten on the roll and you won't be able to remove it without damaging the roll. As long as there is just a spec of plastic on the roll you will have paper jams. There should be transparency sheets for laser printers to, but always make sure you have those before using in a laser printer.
Home sensor error
Try to disassemble the printer. On the left side try to find magnetic clutch with small tension spring. This must be the problem. You can disconnect the spring and try to cut a few mm of springs length, so she will become stronger. In Case You Still face Problem and Need Online Assistance Then Please Follow Us For On :
Xerox Printer Support
Program to reset unit imaging xerox phaser 6110 please
Image units can't be reset by software. There is a chip that needs to be replaced on the cartridge if you refill it with new toner. It should be available from the same place you got the toner. (I assume you refilled it and it still says it is out of toner)
12/9/2011 4:23:03 AM •
Xerox Phaser ...
•
Answered
on Dec 09, 2011
•
1,278 views
Hi
my phaser 6110 go in
For me this used to happen quite a lot. Finally I figured out it was because the waste toner container was full.Buy a new one, or empty it.
10/26/2011 10:40:32 AM •
Xerox Phaser ...
•
Answered
on Oct 26, 2011
•
138 views
How to reset Phaser 6110 imaging unit.
No reset for imaging unit, only when you change it(autoreset).
You can reset Fuser and Transfer Roller this way:
To reset the fuser and transfer roller life usage from the printers control panel:
a. From the main menu select, Menu-Setup --> Maintenance --> Check other.
b. Select the appropriate part name from the list by using the Up Scroll and Down Scroll buttons
c. Select Reset.
10/22/2015 11:36:50 PM •
Xerox Phaser ...
•
Answered
on Oct 22, 2015
•
2,644 views
Not finding what you are looking for?