20 Most Recent Akai CFTD2011 20 in. EDTV-Ready LCD Television Questions & Answers

How to connect an AKAI LCD tv to an INDOOR

Put tv on air, connect antennae to the coaxil input on back of tv.
You can also go to tv's menu and find the "autoprogram" feature and select it. Let it run thuroughly until it is done searching all available channels. Tv. may need to be on channel 3 or 4 to use the antennae/converter box

Akai CFTD2011 20... | Answered on Nov 16, 2017

3 Answers

I am looking for a akai cftd 2011 remote control

I need a remote for a CFTD 2011 for an Akai Tv/DVR

Akai CFTD2011 20... | Answered on Aug 05, 2016

0 Answers

Why can't it be turned on?

Akai CFTD2011 20... | Posted on Jan 19, 2016 | Be the first to answer

1 Answer

Red power lite flashs can not turn tv on

Back - light problem. Check and replace damaged component/s at its back-light inverter board, or replace this board as card basis. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. It will be best to replace the inverter board as card basis.
http://electro-medical.blogspot.com/
To some model sets; especially LED back-lighted types; the back-light inverter circuit will be part of the main power supply board [SMPS]. In such cases, the power supply board might need replacement. To some models sets, the back-light inverter and SMPS section circuit will be integrated at its main board itself. If so; the main board should be replaced.

Akai CFTD2011 20... | Answered on Jan 19, 2016

1 Answer

Necesito control remoto o modelo del control para poder comprar

Verifica en e manua de to remoro universal si aparecen c?dicos para tu TV. Eso ser?a tan solo el primer pasao, Aghora, tienes que verficar si el control exprobramable. Lo mejor es llegae a un acuerso con tu venv¡cedor amable que te devuelava lo pagado si tu control cno funciona

Akai CFTD2011 20... | Answered on May 18, 2015

0 Answers

While watching it, the screen went black

The tv have a long board call a LCD inverter board.This LCD long inverter board,it dead.This long LCD inverter board,help the LCD screen panel to have a backlight to produced a picture.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish long LCD inverter board for the replacement.

Akai CFTD2011 20... | Answered on Dec 18, 2012

0 Answers

Como dar reset tv akai modelo cftd2011

Akai CFTD2011 20... | Posted on Aug 25, 2012 | Be the first to answer

0 Answers

Service manual for Viore 20 inch LCD TV/DVD Model LCD20V31

Akai CFTD2011 20... | Posted on Jun 16, 2012 | Be the first to answer

1 Answer

I am looking for the specs for the wall mount screws on the back of an AKAI CFTD2011 20

If not in the USA contact AKAI in the UK for length and thread type of bolts used for that model for a wall mount.

Akai CFTD2011 20... | Answered on Jun 13, 2012

1 Answer

My tv won`t come on I have a digital Lifestyles

Hello,

The issue you describe is consistent with a power supply board issue. This is the board where the AC goes to. This problem may have occurred as a result of irregular power supply, or excess power supply or power surge.

The TV is receiving current but cannot circulate or transfer the current to other necessary part of the TV because of the defective power supply board. You might be lucky it's just a blow fuse. Also a defective transformer can cause your TV not to power on.

All these can be checked on the power supply board.

But more often bad capacitors causes problem on the power supply board. I do not think the power board needs replacement, rather those defective capacitors is causing this issue. Open unit up and take a look at the power supply board.You will probably see one or more electrolytic filter capacitors that are bulged up in the top-not perfectly flat like the others.

The value of these capacitors will be different, most likely they will be somewhere around-820 to 2200uF/25 V( or /10V sometimes)

You can replace them with same values but I would recommend the voltage rating to be higher(like 35V for an original 25V) for reliability purposes.

What happens is,these bulged top capacitors will cause a low and unfiltered DC voltage=main board will malfunction(the relay will keep clicking until the caps are holding enough charge to bring the voltage up over a threshold point).

You can buy these capacitors at any Fry's or Radioshack store or you can order them online at vendors like "mcmelectronics.com"(look for electrolytic capacitors). After replacing these capacitor(capacitors) most likely the normal operation will be restored. Or you can by a refurbished complete power board to save you some stress.

Note: There may be also some other causes for this symptom ,like a defective T con board ,or main board,but the bulged top capacitors are the most common cause for this issue.

If you don't know about TV repairers, take the TV to the nearest repairman to fix the fault for you. Also, note that TV stores a lot of current, so wait a while before opening the TV back cover.

I hope this helps.

Regards

Akai CFTD2011 20... | Answered on Nov 09, 2011

1 Answer

Need a manual and remote for Akai CFTD2011. Do you

Hi try to check this link http://www.remotes.com/ and this one http://www.replacementremotes.com/store/prodthumbs.cfm?ns=1&keyword=akai&category=All+Brands%2FType+brand Hope this helps good day and best regards.

Akai CFTD2011 20... | Answered on Sep 23, 2011

1 Answer

AKAI MODEL CFT2716. AT POWER ON TV COMES

AKAI MODEL NUMBER PT50DL24 it turns on then goes off n all th screen says LAMP TEMP WHAT DOES THAT MEAN N WHAT DO I ND TO GET IT WORKING

Akai CFTD2011 20... | Answered on Jul 14, 2011

3 Answers

Cracked screen

If you are no longer using anything, can I have the remote? I lost mine, and cannot find one online. I will even pay you for it. Please contact me at [email protected]

Thanks

Akai CFTD2011 20... | Answered on Feb 17, 2011

0 Answers