20 Most Recent
Canon PIXMA Pro9000 InkJet Photo Printer - Page 8 Questions & Answers
How to replace printhead on Canon MX922 printers and post 2016 Pixma Printers
Canon made it a bit tricky to replace printheads in newer Pixma models. We show an easy wasy to replace or remove printhead for cleaning on all newer Canon Pixma models. This will apply to MX920, MX922, MX923, MX924, MX925, MX926, MX927, MX928, MG5420, IP7220, and all pixma printers that use 250 and 270 series ink cartridges. Video tip for you! Please like and subscribe!
I have a Pixma iP7220 with 8 lights flashing indicating the ink absorber is full. How do I empty it?
1, These printers have a built-in ink cleaning system, and whenever the ink is cleaned inside the printer, the waste ink is deposited into this part of the printer. 2, Disclose the cartridge access door of the printer so that the printhead can be removed from the printer. 3, Make sure that you remove the printer that pad and clean it carefully. Make sure that you do not damage the other parts of the printer while removing it. Use a lint-free cloth to clean the pads. 4, After cleaning it replace the parts back into the printer. If the above-mentioned steps are followed correctly, the issue gets resolved, and the lights stop blinking.For more printer related queries just give a call @ 1-866-293-9220.
How do I write serial number to Canon Pixma G3400? Service tool v4905, v5103 get an error 002.
Improper installation of the printer driver.
- Damaged cable connector.
- PC is not capable enough to handle the tasks.
- Solve the issues by following the steps below
- Download the correct version of the printer driver that suits your printer model.
- Install the driver file by following the on-screen instructions of the installer.
- Check the cable connector plug for any dust settlement.
- Clean the cable carefully and reinsert it.
- Check the system requirements of the printer and cross check it with the computer.
- If it does not meet the needs of the printer, the printer cannot be connected, and the error continues to exist. for more support call our Toll-Free 1-866-293-9220
Ink absorber full on a canon mp990 - Canon PIXMA MP990 All-In-One InkJet Printer
Try the following steps. I tried it on my MP990 and it worked.
- Make sure the printer is turned off.
- Press and hold the Resume button (triangle inside a circle).
- Whilst it is held down, hold down the Power button. The green led light should come on.
- Keep the Power button held down. Release the Resume button and then press it twice. The light should go amber, then green again.
- Release the Power button.
- Press the Resume button four times and then press the Power button straight after to confirm the selected action (Reset Counter Absorber).
- Turn off the printer and then turn it on again
If you need further help, I’m available over the phone at
https://www.6ya.com/expert/alex_22751bbefa74c3d0
How doe i fix the error on my printer?
The problem is with the purge unit. The wiper blades may be stuck or there might be some object like paper stuck in the area. Just open the top and see if there is anything obstructing it.
Canon pixma e505
Assuming your using Windows 7.
http://www.downloads-drivers.com/2013/04/canon-pixma-e500-drivers-for-windows-7.html
Not finding what you are looking for?