20 Most Recent RCA (RC1000A) Car Audio Amplifier Questions & Answers

You have a ground fault. Check all ground wires and then make sure the rca cables are not broken in any places. If everything is good there is a ground fault inside the amp.

go into your stereo settings change mono to stereo lol that simple

If it is an RCA television and has a black screen, you need a new one. They are low quality and not worth repairing. https://www.google.com/search?q=RCA+black+screen ..

Adding Bluetooth functionality to a Rock-Ola 55015-1A Amplifier involves a few steps and considerations to ensure compatibility and proper functionality. Here's a general guide on how to add Bluetooth to your Rock-Ola 55015-1A Amplifier: 1. Gather the Necessary Equipment:

• Bluetooth audio receiver module
• Wiring tools (soldering iron, wire strippers, solder)
• Audio cables (3.5mm or RCA)
• Power supply (if required for the Bluetooth module)

The installation wiring diagram is shown on page 13 of the manual, available at https://www.pioneerelectronics.com/PUSA/Unassigned-Content/Manuals/DEH-X5600HD+OWNERS+MANUAL . The w/r port is for a hard-wired remote control that was sold separately. RCA cables are used with the DEH-X56HD to connect a power amplifier to a sub-woofer or rear speakers. See pages 12 (for setting the unit correctly) and 14 (for the wiring diagram). I hope this helps. Cindy Wells

can you elaborate all that, no sub maker/brand model told) tell it all what works and does not work both. ones =once? well it has 2 jacks sub1 and sub2. so swap them if the problem fails on moved sub the sub is bad. if the new moved sub fails on same channel the channel is bad in the head, or cables are bad. then swap cables. there are 3 fail points here. the main head. out. sub1/2 2 cables RCA SIMPLE COAX , easy to buy cheap and replace. 2 subs. super easy to diagnose any like this 2 subs. (it's redundaNT bliss) my actual sub has power AC and rear volume and on/off on rear of sub speaker, so any of that can be wrong, but not told you what you have, we can not see what you have at hand.

ask RCA or google

It sounds like a cooling fan has stopped

LEFT FRONT==WHT/BLK-NEGATIVE LEFT FRONT==WHT=POSITIVE RIGHT FRONT==GRAY/BLK=NEGATIVE RIGHT FRONT==GRAY=POSITIVE RIGHT REAR==VIOLET/BLK=NEGATIVE RIGHT REAR==VIOLET=POSITISVE LEFT REAR==GREEN/BLK=NEGATIVE LEFT REAR==GREEN=POSITIVE YOU NEED THE CONNECT A HI/LO LEVEL TO THE REAR SPEAKER WIRES TO THE REAR SPEAKER WIRES TO GET SIGNAL TO THE AMP;;

This is a sign that the amp is being overtaxed by a subwoofer or other speakers to the point where it simply can't provide enough power. In home audio setups, clipping is typically caused by an underpowered amp or inefficient speakers, but loose or burnt wires can introduce similar problems in cars.

make sure your rca are not up against any heavy metal or pinched by something. cheap rca cables have no type of insulations coating and when up against metal will cause interference. mine did the same thing when I ran it up against the seat belt bracket... pull it out from where you have it routed from but leave it all hooked up and see if it still MAKING the same noise if it goes away then try reroute or get better rca and make sure no pinched wire hope this helps .... always go with good rca cables

White and red

Hmm, even the actual manual is a little confusing, it covers too many models.It suggests if you have 2 sets of RCA's they are OUTPUT ONLY, so you can run external amps and save the units amp chips.The external amps will come on automatically if connected correctly.http://manual.kenwood.com/files/B64-2926-10.pdfFull wiring diagram on page 25 :0D

Yes. Positive wire to center pin ground to outer ring.

I think your best chance for a replacement would be a place called Allied Electronics. They have online service. The other option is to change the connector style. Get a new Male and Female of a light duty type and replace it in your unit. You will have to dismantle the player to do this and will require some soldering.

Jess, do a wiggle test on cables when you have volume, wiggle wires one at a time to see if sound goes out or static. press the helpful button

bad cable? try a new or known good cable first.

i just sold one,sorry check ebay

bring it back if its new