20 Most Recent
APC BE500R Back-UPS ES 500 (BPAPWBE500R) UPS System - Page 5 Questions & Answers
APC 2200 RM XL AVR relay fault
i need help about APC 1500V
6 LEDs are Blinking simultaneously, did anyone tell me what part of hard need replace to remove this fault
Where can I find a service manual or schematic for this device?
User Manuals are no longer available. Internet searches turn up only manuals for the United Kingdom version (BE325-UK). Sadly, such links are usually marked as "BE325" or BE325R" because most people are ... well, see assumption below.
No service information (schematics, etc.) was ever available; and never will be. To be frank, manufacturers of this type of equipment start out with the assumption that all users are em oh are oh ens -- an idea the Internet does not dispel, sadly -- and should never, ever be allowed to open the case. I suspect they will gladly permanently seal the battery into the case if they ever find a battery technology that can last as long as the warranty period. LOL
I have a problem with 4 XR frames the UPS see's them as 1,4,2,3 instead of 1,2,3,4
well as long as the ups sees them all , im not clear why that's a problem , but anyways this is a common thing that happens when doing a hot swap battery replacement , anyway if you really want to reset them back in order then you'll need to bypass the load (or remove it) power down ups and remove its input power too then remove all four trays of battery's , wait a few minutes till the caps die off and then put trays back in the sequence you wish it to be , then repower input wait 4 it to go online (5 min) and then add back load , this should make it go back to a fresh start up , but yo'll need to do this each time you remove trays
Frequent Disconnection From Internet
disconnecting from internet is a bad configuration of the Modem Router.Also bad signal from your internet provider.check all wiring,and telefone line that holds the ADSL signal.rusted telephone line connections do that trouble.
How do I take apart an APC BX900R?
simply pull out the from side of the UPS, disconnect the batteries from inside, unscrew 4 screws in the back side than pull out the internal components. first check individual battery voltage to be > 12.5Vdc, other wise replace batteries, any how when UPS is in charging mode fan is on
Not finding what you are looking for?