20 Most Recent D-Link AirPlus G DWL-G710 Wireless Range Extender Questions & Answers

You cannot configure the DLink by the URL address http://dlinkap?
You connect a LAN cable from your computer to the DLink.
Then open Internet Explorer and enter the URL http://192.168.0.1
the default login = admin
the PW is blank (just press Enter)
You can now configure the DLink.

address to access d-link DAP-1150
http://192.168.0.50

you have to make sure that your ip address is around 192.168.0.xx

Did you power on the device? Is it properly connected? To what is it connected? Are you connecting it wireless or locally? The best option would be to download the manual and then go trough a troubleshooter, since from here and with such little info I can not help you... Check out YUNO PDF for manuals ;)

Hi There

If you have not changed teh username and password, the username should be : admin and the password should be admin or just left blank.

If the username and passhave been changed, you can reset your router to the original factory settings by pressing the reset button at the back of the router and holding it in for about 10 seconds. you might have to use a thin object to get into the little hole where the reset button resides. Once reset, the username and password as above will work.

Have you tried a new power supply, DLinks are unfortunatly renouned for power supply faults

I see no "Scan" button on the D-Link G710. "Scan" is on one of the pages once one accesses the device --which I cannot do.

Use Dlink emulators here ->link.

Make sure you are using the right range of IP addresses, for instance, if your device has a default address of 192.168.0.1, then your computer must have a manually input address of something like 192.168.0.2, otherwise the devices will not communicate. You can change the address on your computer be going into your network connections folder, right clicking on your LAN folder, selecting properties, then right click on TCP/IP protocal on the protocal list, and also select properties. Here, you must uncheck the "Automatically Obtain IP Address" option and input the address shown above. The next two boxes will be 255.255.255.0 and for Default Gateway enter your devices IP address. Don't worry about the DNS address for now. Press ok to save the settings. You may have to restart your computer when you are finished. I hope this information helps you. Good luck!